Brand: Husqvarna
Category: Dust Extractor
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for W 250 P
Uploaded: Nov. 21, 2025, 6:50 p.m.
Manual Publish Date: 2023-01-01
Warranty Information
Product liability is disclaimed for damages caused by improper repair or unauthorized parts/accessories.
To start and stop the W 70
- Push the button (1) to start the product.
- Push the button (0) to stop the product.
To start and stop the W 70 P and the W 250 P
- The motor switch is the button A and the pump switch is the button B referring to the figure.
- Push the button (1) to start the product.
- Push the button (0) to stop the product.
After use
- Switch off the suction apparatus with the switch.
- Disconnect the power cord. Do not remove the pump cable.
- Empty and clean the suction apparatus and the accessories used.
Troubleshooting and error codes
| Issue | Cause | Solution |
|---|---|---|
| Motor does not start | No power | Connect the product |
| Cable defective | Replace the cable | |
| Switch defective | Replace the switch | |
| Wrong fuse | Connect to correct fuse | |
| Motor stops immediately after starting | Shortcut in cable/machine | Order service |
| Motor runs but there is not suction | Hose not connected | Connect the hose |
| Hose blocked | Clean hose | |
| Floating device activated. | Inspect water level and damages on the float. | |
| Motor runs but there is poor suction | Hole on the hose | Replace hose |
| Filter clogged | Clean filter/ Replace filter | |
| Loose suction unit | Adjust | |
| Dirt in the hose or intake | Clean the hose and intake | |
| Defective gaskets | Replace affected gaskets | |
| Blocked or defective check valve. | Clean or replace the check valve. | |
| Dust blown from motor | Wrongly assembled or damaged filter system 3 | Adjust/ Replace filters |
| Poor pumping | The pump or tubes are blocked4 | Clean the pump, check valve and hose |
| Abnormal noise | Order service |