Manual for W 250 P

Manual for W 250 P

Brand: Husqvarna

Category: Dust Extractor

Document Type: Manual

Language: EN

Uploaded: Nov. 21, 2025, 6:33 p.m.

Basic Operation and Maintenance

This manual describes the maintenance and repair of the W 250 P Dust Extractor. It includes safety instructions, a maintenance schedule, cleaning procedures, and troubleshooting steps.

Key Operations:

  • Regular checks of power cord, plug, and sockets.
  • Cleaning the container and flushing the pump if applicable.
  • Checking wheels, hoses, and gaskets for damage.
  • Ensure proper connection to a grounded power source.
  • Use only original spare parts for repairs and maintenance.

Refer to the specific sections for detailed instructions on disassembly, assembly, and component-specific repairs.

Troubleshooting and error codes

Problem Cause Solution
The motor does not start. There is no power supply. Connect the product to a power source.
The power cord is defective. Replace the power cord.
The ON/OFF switch is defective. Replace the ON/OFF switch.
The motor stops immediately after you start the product. There is an incorrect fuse. Connect to correct fuse.
There is short circuit in a cable or the product. Do servicing on the product.
The motor operates but there is no suction. The hose is not connected. Connect the hose.
The hose is clogged or blocked. Clean the hose.
The float device causes a blockage of the airflow. Do a check of the water level and damage on the float device.
The motor operates but the suction is unsatisfactory. The hose is damaged. Replace the hose.
The top cover is loose. Adjust the top cover.
There is dirt on the lid at the bottom of the container. Clean the lid at the bottom of the container.
The gaskets are defective. Replace the defective gaskets.
The check valve is blocked or defective Clean or replace the check valve.
The pump operation is unsatisfactory. The pump is blocked. Clean the pump and do a check of the valve hose.
Unusual noise. N/A Do servicing on the product.
Privacy Policy