Manual for HA-W600RF-J/C

Brand: JVC

Category: Audio System

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: Nov. 21, 2025, 8:57 p.m.

Manual Publish Date: 2006-01-01

Warranty Information

The manual does not contain explicit warranty information.

Listening to the sound from the base station:

The base station transmits FM signals. Ensure the AV equipment is connected and playing. The base station turns on automatically with Auto Power On function. Press the POWER button on the headphones to turn them on. They will automatically tune in to the signal. Adjust the volume on both the AV equipment and the headphones. To turn off, press POWER on the headphones and stop playback on the AV equipment. The base station has an Auto Power OFF function.

Selecting a better reception channel: If the sound is noisy, use the CHANNEL selector on the base station to choose a different channel. Press AUTO SCAN on the headphones to tune to the new channel. Repeat to find the best channel.

Call through the base station: Press and hold the CALL button on the base station to interrupt playback and speak. Release CALL when finished. Do not speak too loudly or when the headphones are close to the base station.

Troubleshooting and error codes

Symptom	Cause/Remedy
No sound comes out at all.	• Turns on the power of the headphones. • Start playback on the AV equipment connected to the base station. • Check the connection between the base station and the AV equipment. • Turns up the volume of the headphones or the connected AV equipment to an appropriate level. • Fully charge the headphones' battery.
No sound comes out from R-channel.	• Check the connection between the base station and the AV equipment. • Sound comes out only of L-channel when the base station is connected to the monaural audio output. Convert the mini plug to the base station from stereo to monaural with the plug adaptor (not supplied).
Sound is distorted.	• The headphones' battery will soon run out. Fully charge the battery. • The volume of the headphones and/or the connected AV equipment is too high. Adjust their volume to an appropriate level.
Sound is noisy.	• The headphones' battery will soon run out. Fully charge the battery. • Switch the base station channel to another and press AUTO SCAN on the headphones. • The volume of the connected AV equipment is too low. Adjust the volume as high as possible without causing distortion. • Too far from the base station. Use the headphones within the range of the base station (see page 8).
Cannot charge the battery.	• Check the contact of the charging terminals on the base station and the headphones. • Check the polarity of the battery. • The cycle life of the battery ended. Replace with the new battery (see page 6).