Brand: JVC
Category: Audio System
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for UX-5000
Uploaded: Nov. 21, 2025, 6:45 p.m.
Warranty Information
No warranty information found in the provided pages.
Features
- COMPU PLAY for one-touch operation of CD, Radio, or External Equipment.
- Active Hyper Bass Super PRO circuitry for enhanced low frequencies.
- 45-station preset capability (30 FM, 15 AM/MW/LW) with auto-seek and manual tuning.
- Versatile CD options: repeat, random, and program play.
- Timer functions for automatic system on/off.
- Connectivity for external units like MD recorders and tape decks.
Common Operations
- Turning On/Off: Press the / button. System remembers last mode. For complete power off, unplug AC cord.
- Adjusting Brightness: Use the DIMMER button on the remote.
- Adjusting Volume: Use the VOLUME control on the unit or VOLUME +/- buttons on the remote.
- Bass Boost: Press the AHB SUPER PRO button for enhanced bass at low volumes.
- Tone Control: Use BASS and TREBLE buttons on the remote to adjust levels (-6 to 6).
- Showing Time: Press the DISPLAY or CLOCK button to cycle through clock display modes.
Troubleshooting and error codes
| Symptom | Possible Cause | Action |
|---|---|---|
| No sound is heard. | Connections are incorrect, or loose. Headphones are connected. |
Check all connections and make corrections. (See pages 4 - 5.) Disconnect the headphones. |
| Poor radio reception | The antenna is disconnected. The AM Loop Antenna is too close to the System. The FM Wire Antenna is not properly extended and positioned. |
Reconnect the antenna securely. Change the position and direction of the AM Loop Antenna. Extend FM Wire Antenna to the best reception position. |
| The CD skips. | The CD is dirty or scratched. | Clean or replace the CD. |
| The CD does not play. | The CD is upside down. The path between the Remote Control and the sensor on the Unit is blocked |
Put the CD in with the label side up. Remove the obstruction. |
| Unable to operate the Remote Control. | The batteries have lost their charge. | Replace the batteries. |
| Operations are disabled. | The built-in microprocessor has malfunctioned due to external electrical interference. | Unplug the System then plug it back in |