Brand: JVC
Category: Camcorder
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for TK-C655
Uploaded: Nov. 21, 2025, 7:12 p.m.
Warranty Information
Refer to the manual for specific warranty details, as it is not summarized here.
Introduction
This manual provides instructions for the JVC TK-C655 and TK-C676 Dome Type Cameras. It covers features, safety precautions, installation, setup using the RM-P2580 remote control unit, and troubleshooting.
Key Features
- DSP with wide dynamic range
- Day/night surveillance
- Private masking facility
- High-speed pan/tilt table
- High-sensitivity CCD and bright zoom lens
- Optical + electronic zooming (TK-C655 only)
- Optical + electronic zooming (TK-C676 only)
- Simplified waterproof design (TK-C676 only)
Installation & Setup
Detailed instructions are provided for connecting the camera, mounting it, and configuring settings using the RM-P2580 remote control unit. This includes setting up various functions like auto pan, auto patrol, auto trace, and position titles.
Troubleshooting
A troubleshooting section addresses common issues such as 'Picture is not displayed', 'Power cannot be turned on', and 'Video sync error'.
Troubleshooting and error codes
| Symptom | Cause (Information) | Remedy |
|---|---|---|
| Picture is not displayed. | • Is there a problem in the power cable(s) connecting the camera to the power supply unit? (If the power cable(s) are too long or of an inadequate size, the correct voltage may not be supplied due to an increase in cable resistance.) |
• Use cable(s) with low cable resistance and of the correct cable length. (Ensure that the voltage supplied to the terminal board is correct during camera operation, i.e. when the rated current is flowing through the camera.) |
| • Are cables connected properly to the terminal board on the Ceiling Mount ? | • Connect the cables properly. | |
| Power cannot be turned on. | • Is there a problem with the power cable(s) connecting the camera to the power supply unit? (If the power cable(s) are too long or of an inadequate size, the correct voltage may not be supplied due to an increase in cable resistance during the pan/tilt operation.) |
• Change power cable(s) to one(s) of lower resistance (i.e. thicker or shorter cable(s)). (P. 16) |
| Video sync error occurs. | • When LL is set, does the power supply frequency match the video frequency (50 Hz)? • Is a large noise interfered with the power supply? |
• Use a stable power supply with a matching frequency. • Prevent any penetration of noise in the power supply. |