Brand: JVC
Category: Projector
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for DLA-RS2
Uploaded: Nov. 21, 2025, 6:45 p.m.
Warranty Information
Retain your Bill of Sale for Warranty Service. Please refer to qualified service personnel for repairs.
Projecting Image
- Remove the lens cap.
- Insert the power plug into the power outlet and connect to the unit.
- Turn on the power using the remote or unit button.
- Select the input mode (HDMI 1, HDMI 2, COMP., VIDEO, S-VIDEO).
- Play back the selected device.
- Adjust the position of the projection screen.
- Adjust the image size (zoom) and focus using the TEST pattern.
- Turn off the power when finished.
Cleaning and Replacing the Filter
- Remove the inner filter by pushing the claw and lifting up.
- Clean the filter with water, dry it, and use neutral detergent if soiled.
- Reinstall the inner filter, ensuring claws are locked.
Troubleshooting and error codes
| Troubleshooting | Possible Cause | Solution |
|---|---|---|
| Screen is blank | Projector is not turned on. | Turn on the power. |
| No signal input. | Check the connection and select the correct input mode. | |
| Lamp is not lit. | Check the lamp status indicator. Replace the lamp if necessary. | |
| Image is distorted | Projector is not perpendicular to the screen. | Install the projector and screen perpendicular to each other. |
| Lens is not adjusted properly. | Adjust the focus and zoom. | |
| Remote control not working | Batteries are exhausted. | Replace the batteries. |
| Remote control is too far from the projector. | Move closer to the projector. |