Brand: KENWOOD
Category: Dishwasher
Document Type: Manual
Language: EN
Manual for KDW12SS/B
Uploaded: Nov. 21, 2025, 9 p.m.
Warranty Information
Refer to the manual for specific warranty details.
Starting a Wash Cycle
After installation, turn on the water and partially open the dishwasher door. Press the ON-OFF button (A). The "B" indicator light will illuminate. To select a wash cycle, press the cycle selection button (G) until the desired cycle's indicator light (F) illuminates. Close the door to start the cycle. The cycle can only be modified if it has just begun. To cancel, press ON-OFF (A) and restart the cycle selection.
End of Wash Cycle
The end of the cycle is signaled by a double acoustic signal and blinking "F" light. Open the door, turn off the appliance (ON/OFF switch), and turn off the water supply. Wait a few minutes before removing dishes.
Delay Start
Press the "J" button to delay the start for 2, 4, or 6 hours. The "I" light indicates the delay duration. Set the wash cycle as usual. The "I" light blinks during the delay period.
1/2 Load Button
Use button "C" to wash only the upper rack for smaller loads, saving energy and water. Not applicable for heavy duty cycles.
Troubleshooting and error codes
| Problem | Possible Cause | Solution |
|---|---|---|
| The Dishwasher Does Not Start | Plug not inserted correctly | Check plug insertion |
| No power in the house | Check house power | |
| Door not closed properly | Ensure door is closed | |
| ON-OFF switch is off | Turn ON-OFF switch to "ON" | |
| Water supply is turned off | Turn water supply on | |
| The Dishwasher Does Not Load Water | Water not turned on or hose not connected | Turn water on and connect hose |
| Insufficient water pressure | Check house water pressure | |
| Water supply hose is kinked or bent | Straighten hose | |
| Water supply hose filter is clogged | Clean filter | |
| The Dishes Are Not Clean | Water not turned on or hose not connected | Turn water on and connect hose |
| Insufficient water pressure | Check house water pressure | |
| Water supply hose is kinked or bent | Straighten hose | |
| Water supply hose filter is clogged | Clean filter | |
| The Dishwasher Does Not Drain | Drain hose is kinked or bent | Straighten drain hose |
| Lime Deposits or a White Film Form on the Dishes | Salt container lid not closed properly | Close salt container lid |
| Rinse aid dosage incorrect | Adjust rinse aid dosage |