Brand: KRAUSE & BECKER
Category: Paint Sprayer
Document Type:
Language: EN
Manual for 60600 - Troubleshooting and error codes + PDF Download
Uploaded: April 7, 2025, 8:16 p.m.
Manual Publish Date: 2012
Warranty Summary
This product has a limited 90 day warranty against defects in materials and workmanship.
Getting Started:
- Familiarize yourself with the Paint Sprayer's parts.
- Attach paint hose to paint hose outlet and paint gun.
- Set pressure control knob to Low Pressure Spray.
Priming:
- Separate priming tube from suction tube.
- Place priming tube in waste bucket.
- Submerge suction tube in paint or solvent.
- Set Prime/Spray switch to Prime.
- Adjust pressure control to Prime/Clean.
- Plug in and power on, let fluid discharge for 30-60 seconds, then power off.
Painting:
- Submerge suction tube in paint.
- Power on, switch to Spray mode, and begin painting with steady strokes.
- Adjust nozzle and pressure as needed.
Cleaning:
- Power off, switch to Prime, and relieve pressure.
- Remove spray tip.
- Flush system with water or solvent until clear.
- Disassemble and clean parts.
Troubleshooting and error codes
| Problem | Likely Solutions |
|---|---|
| Pump will not prime. | Press the red inlet release button underneath the pump to loosen the inlet check ball. |
| Decreased output. | Obstructed trigger. Clean around trigger to ensure movement. |
| Inconsistent paint flow, blobs and splatters. | 1. Clean, adjust or replace Spray Tip or Fluid Filter. 2. Remove paint and filter it. |
| Paint surface is bumpy or has orange peel texture. | 1. Paint must be thinned properly before spraying. 2. Adjust Fluid Control Knob. 3. Hold spray gun closer to surface during spraying. |