Manual for TVNC362KLA0

Brand: LG logo LG

Category: Air Conditioner

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: Nov. 21, 2025, 7:46 p.m.

Warranty Information

Refer to the product label for specific warranty information.

1. Remove the battery cover by pulling it according to the arrow direction.

2. Insert new batteries making sure that the (+) and (-) of battery are installed correctly.

3. Reattach the cover by sliding it back into position.

NOTICE: Use 2 AAA(1.5volt) batteries. Do not use rechargeable batteries.

• The remote controller may be stored by mounting it on a wall.

• To operate the room air conditioner, aim the Remote Controller to the signal receptor.

Receives the signals from the remote controller. (Signal receiving sound: two short beeps or one long beep.)

On/Off: Lights up during the system operation.
Filter Sign: Lights up after 2400 hours from the time of first operating unit.
Timer: Lights up during Timer operation.
Outdoor Unit Operation: Light up during outdoor unit operation. (Cooling model only)
Defrost Mode: Lights up during Defrost Mode or Hot Start operation. (Heat pump model only)

Remote Control Operation

The Remote Controller transmits the signals to the system.

1 START/STOP BUTTON: Operation starts when this button is pressed and stops when the button is pressed again.
2 OPERATION MODE SELECTION BUTTON: Used to select the operation mode.
3 ROOM TEMPERATURE SETTING BUTTONS: Used to select the room temperature.
4 INDOOR FAN SPEED SELECTOR: Used to select fan speed in four steps low, medium, high and CHAOS.
5 JET COOL BUTTON: Used to select jet cool mode.
6 CHAOS SWING BUTTON: Used to stop or start louver movement and set the desired up/down airflow direction.
7 ON/OFF TIMER BUTTONS: Used to set the time of starting and stopping operation.
8 TIME SETTING BUTTONS: Used to adjust the time.
9 TIMER SET/CANCEL BUTTON: Used to set the timer when the desired time is obtained and to cancel the Timer operation.
10 SLEEP MODE AUTO BUTTON: Used to set Sleep Mode Auto operation.
11 AIR CIRCULATION BUTTON: Used to circulate the room air without cooling or heating.
12 ROOM TEMPERATURE CHECKING BUTTON: Used to check the room temperature.
13 RESET BUTTON: Initialize remote controller.
14 2nd F Button: Used prior to using modes printed in blue at the bottom of buttons.

Case	Explanation	See page
The air conditioner does not operate	• Did you make a programming error? • Has the fuse blown or the circuit breaker tripped?	-
The room has a peculiar odor	Check if the odor is due to humidity from the walls, carpets, or furniture in the room.	-
Condensation seems to be leaking from the air conditioner	Condensation occurs when the airflow cools the room's warm air.	-
The air conditioner does not operate for about 3 minutes after startup	• It is the mechanism protector. • Wait for about three minutes, and the air conditioner will start to operate.	-
Does not cool or heat effectively	• Is the air filter dry? Refer to the air filter cleaning instructions. • Was the room very hot when the air conditioner was turned on? Let the room cool down. • Was the temperature selected incorrectly?	21 11, 14
The air conditioner makes noise	• Are the inlet and outlet ports of the indoor unit obstructed? • For a sound produced by flowing water: This is the sound of Freon flowing into the air conditioner. • For a sound like compressed air escaping: This is the sound of dehumidification water being processed inside the unit.	-
The display panel is barely visible, or not visible at all.	• Are the batteries depleted? • Are the batteries inserted in the wrong direction (+ and -)?	-
Creaking noises are heard	This sound is generated by the expansion/contraction of the intake grille, etc., due to temperature changes.	-