Brand: Miele
Category: Dishwasher
Document Type: Parts/Service
Language: EN
Parts/Service for G1000 / G2000 Dishwashers
Uploaded: Nov. 21, 2025, 6:11 p.m.
The Miele G1000/G2000 Dishwashers technical manual provides comprehensive information for service and repair. It details construction and design, installation procedures, commission and operation, function descriptions, and extensive fault diagnosis and repair summaries. Key sections cover electrical and plumbing connections, component layouts, and troubleshooting for various error codes (F11-F91) and operational issues. Specific procedures are outlined for diagnosing and rectifying problems related to heating, water intake, draining, pump operation, sensors, and control modules. The manual emphasizes safety precautions and provides circuit test paths and component identification for effective service.
Troubleshooting and error codes
| Fault Code | Description | Page |
|---|---|---|
| F11 | Water Present In Appliance And Is Not Being Drained Off | 210 |
| F12, F13, F19 | Inlet/Drain LED Flashes During Water Intake, Dishwasher ends selected program. | 211 |
| F14 | With the circulation pump operating after a water intake step, the heater pressure switch is checked to ensure that sufficient water pressure exists in the wash water circuit. | 214 |
| F15 | A water intake fault: hot water is registered | 220 |
| F18 | The water inlet valve is open when it should not be | 214 |
| F19 | Start rinse block water intake / Test routine | 212-213 |
| F24 | Heater relay faulty | 216 |
| F25 | Heating element defective / Heating relay defective | 209 |
| F26 | Water enters the machine exceeding 194°F | 216 |
| F40 | The electronic unit has a fault that cannot be repaired | 217 |
| F42 | Power frequency check | 217 |
| F47 | Communication between selection-display module and Control-power module faulty | 217 |
| F51 | Heater pressure switch check | 217-218 |
| F53 | A Speed Sensor Fault is registered | 220 |
| F63 | A Slide shutter fault is registered | 220 |
| F67 | Circulation pump speed too low fault is registered | 221 |
| F68 | The speed sensor registers that the circulation pump is still operating even after it has been switched off. | 218 |
| F69 | circulation pump blocked | 219 |
| F70 | Float switch fault | 219 |
| F84 | Slide shutter positioning fault | 219 |
| F85 | Slide shutter signal change fault | 219-220 |
| F87 | Sensor softener fault is registered | 221 |
| F88 | Turbidity sensor fault is registered | 221 |
| F91 | Load size registration inactive | 221 |