Brand: Miele
Category: Fridge-Freezer
Document Type: Installation Guide
Language: EN
Brand: Miele
Category: Fridge-Freezer
Document Type: Installation Guide
Language: EN
Uploaded: Nov. 21, 2025, 6:28 p.m.
Warranty information is available via Miele Technical Service or dealers.
| Cause | Remedy |
|---|---|
| The appliance is not operating. | – The appliance is not switched on. → Switch the appliance on. |
| – The plug is not connected to the socket. → Connect the plug. | |
| – The fuse has blown. → Check the fuse. | |
| – The circuit breaker has tripped. → Switch the circuit breaker on. | |
| – The appliance is switched off. → Switch the appliance on. | |
| – The temperature is set too high. → Set a lower temperature. | |
| The cooling is insufficient. | – The appliance door is not closed properly or is open too long. → Close the appliance door. |
| – Insufficient ventilation. → Ensure sufficient ventilation. | |
| – The temperature is set too high. → Set a lower temperature. | |
| – The appliance has been recently switched on or loaded with warm food. → Allow the appliance time to reach the set temperature. | |
| – The appliance is installed too close to a heat source. → Observe the minimum distances. | |
| – The air vents are covered. → Remove any obstructions. | |
| – The appliance is installed in a room that is too warm. → Ensure that the room temperature is within the specified climate class. | |
| – The freezer drawers are overloaded. → Remove some of the contents. | |
| – The evaporator is covered with a thick layer of frost. → Defrost the appliance. | |
| – The ice cube maker is switched off. → Switch on the ice cube maker. | |
| – The water connection is faulty. → Check the water connection. | |
| A loud noise is heard. | – The appliance is not level. → Adjust the levelling feet. |
| – The appliance is touching adjacent cabinets or fixtures. → Ensure sufficient clearance. | |
| – Components inside the appliance may be vibrating. This is normal. | |
| – The fan is running. This is normal. | |
| – The ice cube maker is operating. This is normal. | |
| – The refrigerant flowing through the pipes can cause a faint gurgling or rushing sound. This is normal. | |
| – The compressor is running. This is normal. | |
| Water is leaking. | – The water filter is not fitted correctly. → Fit the water filter correctly. |
| – The water connection is leaking. → Check the water connection. | |
| – The condensate drain is blocked. → Clean the condensate drain. | |
| The door alarm is sounding. | – The appliance door has been open for too long. → Close the appliance door. |
| The display is showing an error message. | – Refer to the relevant section in the operating instructions or contact Miele Service. |