Brand: MITSUBISHI ELECTRIC
Category: Other
Document Type: Installation Guide
Language: EN
Installation Guide for JT-SB116JH-G-NA
Uploaded: Nov. 21, 2025, 9:04 p.m.
Warranty Information
This manual does not contain warranty information.
This manual provides instructions for the safe and correct installation of the Mitsubishi Electric Jet Towel hand dryer. It covers pre-installation checks, installation conditions, the step-by-step installation method, and a final test run. Key steps include checking the installation environment, preparing required items, wiring the unit, securing it to the wall, and setting the heater and air speed switches. Safety precautions and cautions are emphasized throughout.
Troubleshooting and error codes
| Step | What to check for | Check |
|---|---|---|
| 1 | Check the power supply voltage | 120 Vac power being used? Incorrect power supply may cause malfunctions. |
| 2 | Turn the ground-fault circuit interrupter is "ON" | |
| 3 | Maintenance switch is "OFF" | |
| 4 | Insert your hands to check if air is being blown. | Is the air blowing? |
| 5 | Insert your hands to check if warm air is being blown. (When the heater is "ON".) | Is warm air blowing? (If the room temperature is above 86°F(30°C), for safety reasons the heater will not operate even if the heater switch is turned on.) * As the heater is a simple heater, if the room temperature is less than 64°F (18°C), the air may feel cold. Is the heater lamp in the display on? |
| 6 | Is the unit mounted securely without any vibration or abnormal noises? |