Manual for CP-D90DW

Manual for CP-D90DW

Brand: MITSUBISHI ELECTRIC

Category: Printer

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: Nov. 21, 2025, 7:55 p.m.

Warranty Information

Warranty information not explicitly stated in this section of the manual.

Printer Setup Procedure

  1. Position the adjustable paper guides.
  2. Install the print paper.
  3. Install the ink ribbon.
  4. Connect the printer to a personal computer.

Ensure the printing unit is closed after setup.

Handling Paper/Ink Ribbon Sets

Before Printing: Avoid fingerprints/dust; stabilize temperature before use.

After Printing: Avoid contact with organic solvents and soft vinyl chloride.

Storage: Store in a cool, dark place (5-30°C, 20-60% RH), away from direct sunlight and heat. Do not use containers made of soft polyvinyl chloride.

Connecting to a Personal Computer

  1. Turn on the PC.
  2. Install the printer driver (do not connect the printer yet).
  3. Connect the printer to the PC using a USB 2.0 certified cable (2m or less, not supplied).

Printer Driver Installation

The printer driver is required for printing. It is supplied on CD-ROM. Refer to the website for the latest version.

Troubleshooting and error codes

Symptom Check & Remedy
The power is not turned on. Is the power cord plug disconnected from the outlet? Connect the power cord plug to the outlet firmly. The protective circuit may be working. Turn off the power and wait for about two minutes. Then turn on the power again.
The printing unit doesn't open. Are you turning off the power during printing procedure? Turn on the power and then open the printing unit.
The image is not printed. Is the PAPER RIBBON indicator or the ALARM indicator illuminating or blinking? Refer to "Overcoming paper jams." Is the appropriate size of data sent to this unit? Make sure that the appropriate size of image data is sent to this unit. Is the print paper or the ink ribbon used up? Check them. Is the printing unit set firmly? Set the printing unit firmly. When the indicators keep illuminating or blinking though the above operations are performed, remove the ink ribbon and print paper and reinstall them.
An error can not be resolved. Turn off and on the power of the printer with the printing unit set firmly. This printer starts initialization. Press the switch inside of the hole of the front panel with a thin stick or the like for 5 seconds or more.
Privacy Policy