Brand: Motorola
Category: Telephone
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for S3000
Uploaded: Nov. 21, 2025, 7:04 p.m.
Manual Publish Date: 2013-03-21
Warranty Information
This Motorola product has a limited warranty of one year for consumer products and ninety days for accessories.
Getting Started
1. Plug the telephone line cord into the base, then plug the power adaptor into the base and a mains socket. Switch on the power.
2. Install batteries in the handset, slide the cover back, and place the handset on the base to charge for at least 24 hours.
3. Once charged, plug the telephone line cord into the wall socket.
4. Set date and time manually if Caller ID is not available.
Using the Phone
To make a call, press the call button and dial the number.
To answer a call, press the call button or lift the handset.
To end a call, press the end call button.
Use the phonebook to store and recall numbers.
Adjust volume, mute the microphone, and use hands-free mode as needed.
Troubleshooting and error codes
| Problem | Solution |
|---|---|
| The icon is not scrolling during charge | Bad battery contact – move the handset slightly. Dirty contact – Clean the battery contact with a cloth moistened with alcohol. Battery is full – no need to charge. |
| No dialling tone | No power – check the connections. Reset the phone: unplug and plug back in the mains. Batteries are empty – charge the batteries for at least 24 hours. You are too far from the base – move closer to the base. Wrong line cable – use the line cable provided. Line adaptor (when needed) is not connected to the line cord – connect the line adaptor (when needed) to the line cord. |
| Poor audio quality | The base is too close to electrical appliances, reinforced concrete walls or metal doorframes – move the base at least one metre away from any electrical appliances. |
| The Y icon is blinking | Handset is not registered to the base – register the handset to the base. You are too far from the base – move closer to the base. |
| No ring tone | The ring tone is deactivated. Increase the volume. |
| Caller ID service does not work | Check your subscription with your network operator. |
| A phonebook entry cannot be stored | The phonebook is full. Delete an entry to free memory. |
| No display | Try recharging or replacing the batteries. Try disconnecting and connecting the base power supply. If LED is not lit up, then try disconnecting and connecting the base power supply. |
| Unable to register another handset | Maximum number of 5 handsets has been reached. The display shows SEARCHING. You must unregister a handset in order to register a new one. |
| Noise interference on your radio or television | Your base or charger may be too close. Move it as far away as possible. |