Manual for T1

Manual for T1

Brand: Motorola

Category: Telephone

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: Nov. 21, 2025, 6:41 p.m.

Manual Publish Date: 2015-03-30

Warranty Information

This limited warranty covers consumer products for two years and accessories for ninety days.

Getting Started

  • Charge the handset for 24 hours.
  • Connect the base station to mains power and telephone line.
  • Install batteries in the handset.
  • Set date and time.

Using the Phone

  • Make and receive calls.
  • Adjust volume and mute.
  • Use intercom and conference calls.
  • Utilize hands-free function.
  • Access redial list and phonebook.
  • Manage Caller ID and calls list.
  • Set clock and alarm.
  • Customize personal settings (tones, volume, name).
  • Configure base settings (ECO modes, PIN, registration).

Help & General Information

  • Troubleshoot common issues.
  • Understand installation and safety guidelines.
  • Learn about battery safety and environmental considerations.
  • Refer to warranty information.

Troubleshooting and error codes

Problem Possible Solution
No dial tone
  • Use only the telephone line cord supplied.
  • Check that the telephone line cord is connected properly.
  • Check that the mains power is connected properly and switched on.
No display
  • Check that the batteries are inserted correctly and fully charged. Use only approved rechargeable batteries supplied.
  • Check that the handset is switched on. Press and hold [End Call].
  • Reset the base by removing the batteries and disconnecting the mains power. Wait for around 15 seconds before connecting it again. Allow up to one minute for the handset and base to synchronize.
IlIcon flashes
  • Handset is out of range. Move closer to the base.
  • Make sure that the handset is registered to the base.
  • Check that the mains power is connected properly and switched on.
Keypad does not seem to work
  • Check that the keypad lock is not on.
☑ icon is not scrolling during charge
  • Adjust the handset slightly on the base.
  • Clean the charging contacts with a cloth moistened with alcohol.
  • Check that the mains power is connected properly and switched on.
  • The battery is full. When the handset is fully charged, [Battery status] icon will appear steady on the display.
No Caller ID
  • Check your subscription with your network operator.
  • The caller may have withheld their number.
  • The record cannot be found in your phonebook. Check that you have the correct name / number stored in your phonebook, with the full area code.
Cannot register a handset to the base
  • You can register up to a maximum of 4 handsets to a Tl base. You must de-register a handset in order to register a new one.
  • Check that you have entered the correct PIN code (default = 0000).
  • Check that you are at least one metre away from other electrical equipment to avoid interference when registering.
Handset does not ring
  • The handset ringer volume may be set to Off.
Base does not ring
  • The base ringer volume may be set to Off.
Noise interference on my phone or on other electrical equipment nearby
  • Place your Tl at least one metre away from electrical appliances or any metal obstructions to avoid any risk of interference.
Privacy Policy