Manual for NE3707-061

Name: Manual for NE3707-061
Brand: NEC
Availability: InStock

Brand: NEC

Category: Other

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: Nov. 21, 2025, 8:17 p.m.

Manual Publish Date: 2014-02-01

Warranty Information

NEC assumes no liability for incidental or consequential damages arising from the use of this manual.

Read this manual carefully before using the unit.
Keep this manual nearby as a handy reference.
This product is intended for installation in a Restricted Access Location and should only be serviced by qualified Service Persons.
Do not disassemble, repair, or modify the product yourself. Contact a service representative for assistance.
Ensure proper grounding and use designated power cords and outlets.
Avoid operating the product in environments with extreme temperatures, humidity, dust, or corrosive gases.
Do not expose the product to water or liquids.

Connect the power cord to the power supply unit and then to the power outlet.
Observe LED indicators during startup to confirm normal operation.
To disconnect, unplug the power cord from the outlet. Ensure the system is not running critical operations before shutdown.
InfiniBand cables should be connected and disconnected carefully, following specific procedures to avoid damage.

Symptom/Problem	Possible Cause	Troubleshooting Steps
Power is not supplied	No power to the product	Check LED indication. Verify power is supplied to the product (check switchboard, circuit breaker, power cords). Check the status of the power supply unit.
Cannot connect via serial port	Incorrect port configuration	Check connection settings in communication software. Ensure the cable is connected to the correct destination port. Verify the correct RS232 DB9-RJ45 conversion cable is used.
Cannot connect via Ethernet port	Port not properly configured	Configure the port (IP address, etc.) via serial port. Check port configuration using CLI commands. Ensure the cable is connected to the correct destination port.
InfiniBand device not detected	Port issues or cable problems	Check InfiniBand port status LEDs. Verify InfiniBand cable is properly connected, not bent or broken. Ensure the connected device is starting and working correctly. Confirm at least one subnet manager exists in the InfiniBand fabric.