Brand: ÖKO-ARCTIS
Category: Refrigerator/Freezer
Document Type: Manual
Language: EN
Manual for SUPER
Uploaded: April 20, 2026, 7:48 p.m.
- Read operating instructions carefully before use.
- Keep instructions for future reference.
- Observe notes specific to your model.
- Pay attention to safety warnings (triangle symbol).
- Follow step-by-step guidance with the provided symbol.
- Use supplementary information for practical applications.
- Refer to the "What to do if..." section for malfunctions.
Troubleshooting and error codes
| Malfunction | Possible Cause | Remedy |
|---|---|---|
| Appliance does not work, no pilot light is illuminated. | Appliance is not switched on. | Switch on the appliance. |
| Mains plug is not plugged in or is loose | Insert mains plug. | |
| Fuse has blown or is defective | Check fuse, replace if necessary. | |
| Socket is defective | Mains malfunctions are to be corrected by an electrician. | |
| Green light does not light up, yellow light lights up when the fast freeze function is activated. | Green light faulty. | Please inform your customer service. |
| Yellow light does not light up when the fast freeze function is activated, appliance is on | Yellow light faulty. | Please inform your customer service. |
| Appliance cools too much. | Temperature is set too cold. | Turn the temperature regulator to a warmer setting temporarily. |
| The freezer temperature is not sufficient, red light lights up, temperature alarm signal sounds. | Temperature is not properly adjusted. | Please look in the "Initial Start Up" section. |
| Door was opened for an extended period. | Open the door only as long as necessary. Press the fast freeze switch. | |
| A large quantity of warm food was placed in the appliance within the last 24 hours. | Press the fast freeze switch. | |
| The appliance is near a heat source. | Please, look in the "Installation Location" section. | |
| Heavy build up of frost, possibly also on the door seal. | Door seal is not air tight (possibly after changing over the hinges). | Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx. 50°C). At the same time shape the warmed door seal by hand such that it sits correctly. |
| Unusual noises. | Appliance is not level. | Readjust the feet. |
| The appliance is touching the wall or other objects. | Move the appliance slightly. | |
| A component, e.g. a pipe, on the rer of the appliance is touching another part of the appliance or the wall. | If necessary, carefully bend the component out of the way. | |
| The compressor does not start immediately after changing the temperature setting. | This is normal, no error has occurred. | The compressor starts after a period of time. |