Brand: ÖKO
Category: Refrigerator
Document Type: Manual
Language: EN
Manual for SANTO
Uploaded: Nov. 21, 2025, 7:13 p.m.
Warranty Information
None
Starting up and temperature regulation
Insert the plug of the connection lead into the plug socket with protective earth contact. When the refrigerator compartment door is opened, the internal lighting is switched on. The temperature selector knob is located on the RH side of the refrigerator compartment.
Setting "0" means: Off. Setting "1" means: Highest temperature, (warmest setting). Setting "6" (end-stop) means: Lowest temperature, (coldest setting).
The exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on the quantity of food stored and how often the door is opened. The temperatures in the refrigerator compartment and freezer compartment cannot be independently regulated.
Interior Accessories
Storage shelves
Slide one of the full size glass storage shelf into the lowest set of guides, above the fruit and vegetable containers. The height of the storage shelves can be adjusted by pulling the shelf forward until it can be swivelled upwards or downwards and removed.
Troubleshooting and error codes
| Malfunction | Possible Cause | Remedy |
|---|---|---|
| Appliance does not work. | Appliance is not switched on | Switch on the appliance. |
| Mains plug is not plugged in or is loose. | Insert mains plug. | |
| Fuse has blown or is defective. | Check fuse, replace if necessary. | |
| Socket is defective. | Mains malfunctions are to be corrected by an electrician. | |
| Appliance cools too much. | Temperature is set too cold. | Turn the temperature regulator to a warmer setting temporarily. |
| Temperature is not properly adjusted. | Please look in the "Initial Start Up" section. | |
| Door was open for an extended period. | Open the door only as long as necessary. | |
| The food is too warm. | A large quantity of warm food was placed in the appliance within the last 24 hours. | Turn the temperature regulator to a colder setting temporarily. |
| The appliance is near a heat source. | Please look in the "Installation location" section. | |
| Heavy build up of frost, possibly also on the door seal. | Door seal is not air tight (possibly after changing over the hinges). Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx. 50 °C). At the same time shape the warmed door seal by hand such that it sits correctly. | |
| Unusual noises. | Appliance is not level. | |
| The appliance is touching the wall or other objects. | Move the appliance slightly. | |
| A component, e.g. a pipe, on the rear of the appliance is touching another part of the appliance or the wall. | If necessary, carefully bend the component out of the way. | |
| The compressor does not start immediately after changing the temperature setting. | This is normal, no error has occurred. | The compressor starts after a period of time. |
| Water on the floor or on storage shelves. | Water drain hole is blocked. | See the "Cleaning and Care" section. |