Brand: Panasonic
Category: Cordless Phone
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for RP-WF950
Uploaded: Nov. 21, 2025, 6:03 p.m.
Warranty Information
Panasonic Corporation declares this product complies with essential requirements of Directive 1999/5/EC.
Preparation
- Turn on the unit the transmitter is connected to.
- Turn the volume on the sound source up as much as possible without causing distortion.
Operation
- Remove the headphones from the transmitter.
- Reduce the volume of the headphones with the [VOL] dial.
- Switch the [OPR] switch to “ON”
- Put the headphones on.
- Press the [TUNING] button to adjust the frequency.
- Adjust the volume on the headphones.
- To use the SURROUND sound feature, set the [SURROUND] switch to “ON”.
After listening
- Take the headphones off.
- Switch the [OPR] switch to “OFF”.
- Reset the headphones on the transmitter, and recharge them.
- Turn off the unit the transmitter is connected to.
Troubleshooting and error codes
| Problem | Probable cause(s) | Suggested remedy | Page |
|---|---|---|---|
| No sound. | Is the unit that the transmitter is connected to on? | Turn the unit on. | 12 |
| Are the unit and the transmitter connected? | Connect the unit correctly and ensure the plugs are properly inserted. | 10 | |
| Is the volume too low? | If the transmitter is connected to the headphone jack, turn up the volume of the connected unit. | 12 | |
| Turn up the volume on the headphones. | 12 | ||
| Sound is distorted. | Is the input level of the audio signal too high? | If the transmitter is connected to the headphone jack, turn down the volume of the connected unit. | 12 |
| Excessive noise. | Is there an obstruction between the transmitter and the headphones? | Remove the obstruction, move the transmitter, or change position yourself. | 10 |
| • Are other radio waves obstructing the transmitter's waves? • Are the transmission frequency and the receiver's frequency tuned correctly? | Change the transmitter channel using the [CHANNEL] switch, and then press the [TUNING] button on the headphones to adjust the frequency automatically. | 14 | |
| Is the input level of the audio signal too low? | If the transmitter is connected to the headphone jack, turn up the volume of the connected unit. | 12 | |
| No sound, sound is distorted, or there is excessive noise. | Is the OPR indicator dim or does it fail to light at all? | The batteries have run down. Recharge them. If the indicator remains dim after recharging, the batteries have come to the end of their serviceable life and need to be replaced. | 8 |