Brand: PARKSIDE
Category: Garden Tools
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for PERM 1200 A1
Uploaded: Nov. 21, 2025, 6:11 p.m.
Warranty Information
This product comes with a 3-year warranty from the date of purchase against material or manufacturing defects.
Einleitung (Introduction)
Congratulations on purchasing your new electric lawnmower. This manual provides important safety, operation, and disposal instructions. Read it carefully and familiarize yourself with the controls and proper use of the device.
Bestimmungsgemäße Verwendung (Intended Use)
This device is exclusively intended for mowing lawns and grass areas in domestic areas. Do not use in rain or wet conditions. Adult use only; supervised use for individuals over 16.
Übersicht (Overview)
Familiarize yourself with the device components shown in the illustrations (Abb. A, B, C, etc.). Key parts include the start handle (1), handle tubes (2, 4), grass catcher (5), wheels (6), and motor housing (7).
Vorbereitung (Preparation)
Assemble the handle tubes (Section 13). Prepare and mount the grass catcher (Section 13). Adjust the cutting height by mounting the wheels (Section 14).
Betrieb (Operation)
Ensure all screws are tight and safety devices are in place. Plug in the extension cord and then the mains plug. To start, pull the start handle (1) while pressing the safety interlock (12). Release the interlock to stop.
Troubleshooting and error codes
| Problem | Possible Cause | Troubleshooting |
|---|---|---|
| Device does not start | No mains voltage | Check socket, mains cable, plug, fuse; consult an electrician if necessary. |
| Start handle (1) defective | Contact the Service-Center. | |
| Carbon brushes worn | Contact the Service-Center. | |
| Motor defective | Contact the Service-Center. | |
| Motor cuts out | Grass too long | Set a higher cutting height. Lightly lift the front wheels by pressing the upper handle (2). |
| Blockage due to foreign object | Remove foreign object. | |
| Cutting height too low | Set a higher cutting height. | |
| Working result unsatisfactory or motor runs heavily | Blade (26) blunt | Have the blade ground or replaced. |
| Blade area clogged | Clean the device. | |
| Blade (26) incorrectly mounted | Install blade (26) correctly. | |
| Blade (26) does not rotate | Blade (26) blocked by grass | Remove grass. |
| Blade (26) damaged | Replace blade (26). | |
| Abnormal noises, rattling or vibrations | Blade screw (27) loose | Tighten blade screw (27). |
| Blade (26) damaged | Replace blade (26). | |
| Fill level indicator (21) does not function | Dirt | Clean with a soft brush. The fill level indicator must fall shut on its own if it was opened. |