Brand: PARKSIDE
Category: Tools
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for PGG 15 G6
Uploaded: Nov. 21, 2025, 7:57 p.m.
Warranty Information
This product comes with a 3-year warranty from the date of purchase.
Operating the Engraving Tool:
1. Power On/Off: Plug the power cord (3) into a socket. Hold the tool firmly with one hand. Move the ON/OFF switch (1) to position 'I' to turn it on, and to position 'O' to turn it off.
2. Adjusting Engraving Depth: Use the stroke rate regulator (6) to set the engraving depth. A lower setting is usually sufficient for most applications. Turn the regulator towards '+' to increase depth and towards '-' to decrease it.
3. Changing Engraving Tip: When the engraving tip (4) is worn, turn the engraving tip lock (5) counter-clockwise to remove the old tip. Remove the spring and washer. Place the washer and spring onto the new tip, insert it, and turn the lock clockwise to secure it. Ensure the tip is correctly fixed.
4. Work Tips: Hold the tool at an angle, like a pen, with your forearm resting on the table. Apply light pressure with the engraving tip (4) on the workpiece. Test on a scrap piece to determine ideal engraving speed.
5. Cleaning and Maintenance: Unplug the tool before any maintenance. Remove dirt with a dry cloth.
6. Storage: Store the product in a dry indoor area, protected from direct sunlight, preferably in its original packaging.
7. Disposal: Dispose of the product and packaging according to local recycling regulations.
1. Power On/Off: Plug the power cord (3) into a socket. Hold the tool firmly with one hand. Move the ON/OFF switch (1) to position 'I' to turn it on, and to position 'O' to turn it off.
2. Adjusting Engraving Depth: Use the stroke rate regulator (6) to set the engraving depth. A lower setting is usually sufficient for most applications. Turn the regulator towards '+' to increase depth and towards '-' to decrease it.
3. Changing Engraving Tip: When the engraving tip (4) is worn, turn the engraving tip lock (5) counter-clockwise to remove the old tip. Remove the spring and washer. Place the washer and spring onto the new tip, insert it, and turn the lock clockwise to secure it. Ensure the tip is correctly fixed.
4. Work Tips: Hold the tool at an angle, like a pen, with your forearm resting on the table. Apply light pressure with the engraving tip (4) on the workpiece. Test on a scrap piece to determine ideal engraving speed.
5. Cleaning and Maintenance: Unplug the tool before any maintenance. Remove dirt with a dry cloth.
6. Storage: Store the product in a dry indoor area, protected from direct sunlight, preferably in its original packaging.
7. Disposal: Dispose of the product and packaging according to local recycling regulations.
Troubleshooting and error codes
| Problem | Possible Cause | Solution |
|---|---|---|
| The engraving tool does not work. | Not plugged in. | Ensure the power cord is plugged into a socket. |
| Worn engraving tip. | The engraving tip is worn and not producing desired results. | Change the engraving tip (see section 'Changing Engraving Tip'). |
| Uneven engraving. | Incorrect pressure or speed. | Adjust pressure and speed, test on scrap material. |
| Tool overheats. | Prolonged use without breaks. | Do not use for longer than 30 minutes. Allow adequate cool-down time between uses. |