Manual for LX700

Manual for LX700

Brand: PHILIPS

Category: Audio

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: Nov. 21, 2025, 8:08 p.m.

Warranty Information

Warranty invalid if system is opened or repaired by user; consult dealer for issues.

Basic Operation

  • Powering On/Off: Press STANDBY ON to switch on the system. It defaults to the last selected source.
  • Selecting Source: Use the SOURCE button or dedicated buttons (TV/AV, DISC, TUNER, AUX) to choose your input.
  • Volume Control: Adjust master volume with VOL +/-, or individual speaker levels (Subwoofer, Rear, Center) and TV volume (for Philips TVs) using specific buttons.
  • Surround Sound: Press SURROUND to cycle through Dolby Digital, DTS, Dolby Pro Logic II, or Stereo modes. Sound modes available depend on the source material and speaker setup.
  • Sound Effects: Press SOUND to select preset effects like Concert, Drama, Jazz, or Rock to enhance the audio experience.
  • Display Dimming: Use the DIM button to adjust screen brightness (High, Mid, Low).

Troubleshooting and error codes

Problem Solution
No power. Check the connection to the AC power cord.
No sound or distorted sound from speakers Check the connection to the speakers. Adjust the volume. Select the source you wish to listen to. If the muting is on, press the MUTE button. Replace the speaker cables.
No sound is heard from center or rear speakers Check the connections to the speakers. Use the CENTER +/- or REAR +/- to adjust the volume level.
No sound from subwoofer. Check the connections to the subwoofer. Play the bass source.
Noise interfence The unit is too close to a TV set or other electrical appliances, relocate the unit, or turn off other appliances.
Sound cuts off during listening to music The positive and negative speaker cords may have short-circuited. Turn off the power and check the speaker cords.
Sound from the left and right speaker is reversed Turn off the power and turn it on again, then reduce the volume. Check that the left and right speakers are not positioned in reverse order. Check the left and right speakers cables are not connected to the terminals in reverse order.
Considerable noise in radio broadcasts. Tune to the correct frequency. Connect the antenna. Route all connection cables away from the antenna terminals and wires. Fully extend the FM wire antenna. Position for best reception and secure to a wall. Connect an outdoor FM or MW antenna. Adjust the direction and position for best reception. Turn off the equipment causing the noise. Place the antenna farther away from the equipment causing the noise.
The remote control does not function. Point the remote control at the remote sensor of the unit. Reduce the distance to the Receiver. Remove any possible obstacles. Replace the batteries with new ones. Check that the batteries are loaded correctly. Insert the mains plug into an outlet and press the main unit STANDY ON button.
Can't set NIGHT mode Play a source with DOLBY DIGITAL 5.1 channel sound.
The display is dark Press DIM again.
Low bass response Check all speakers for correct polarity.
Can't select DTS mode Check the source's sound output setting and turn on DTS output. Play a source with DTS sound. Select a OPTICAL or COAXIAL source connected by digital cable correctly.
Privacy Policy