Brand: PIONEER
Category: DVD Player
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for DVL-909
Uploaded: Nov. 21, 2025, 6:20 p.m.
Warranty Information
Warranty information is provided on a separate Limited Warranty sheet included with your product.
Basic Operation
Playing LDs (Page 10): Press POWER, OPEN/CLOSE, load disc, press PLAY.
Playing DVDs, CDs, and Video CDs (Page 11): Press POWER, DVD/CD, load disc, press PLAY/PAUSE.
Chapter/Track Skip (Page 12): Use NEXT for forward, PREV for back. FWD/REV for fast forward/reverse.
Stopping Playback & Power OFF (Page 13): Press STOP, then OPEN/CLOSE, remove disc, press POWER.
Continuing Playback (Page 14): Press LAST MEMO during playback to memorize, or during STOP to resume.
Troubleshooting and error codes
| Symptom | Possible causes | Reference page |
|---|---|---|
| Operation | 1. The disc table doesn't stay in even when it is closed. |
p.54 • The disc is dirty. • The disc is not correctly loaded in the disc table. • The region number is different. • There's condensation inside the player. • SECAM system discs cannot be played. |
| Operation | 2. Playback is not possible. |
p.5 p.56 p.53 p.5 • This player is compatible with copy guard analog copy protect technology. • Some discs may feature a copy protect signal. Playing this kind of disc with some TVs may result in horizontal lines in part of the picture and other picture defects, but this does not mean the player is malfunctioning. |
| Operation | 3. The picture is unclear during DVD play. |
p.4 • This player is compatible with copy guard analog copy protect technology. • Some discs may feature a copy protect signal. If you record this kind of disc on a VCR and play it back, or play this kind of disc through a VCR, the copy guard system prevents normal playback. |
| Operation | 4. If I record a DVD on a VCR and play it back, or play a DVD through a VCR, the picture is unclear. |
p.4 • The selected operation is not possible with that disc. |
| Operation | 5. The mark appears on screen. |
p.4 • Press the STOP (■) button, and then press PLAY again. |
| Operation | 6. The picture stops, and operation buttons do not function. |
p.42 • Video signal output is set to COMPONENT VIDEO OUT. |
| Operation | 7. The picture is black and white. | |
| Remote control | 8. The remote control doesn't operate. |
p.48 • The rear panel control input jack on the player is being used. • You are too far from the player. Or the angle between the remote control and the remote control reception window is too large. • The remote control's batteries are dead. • Some TVs with wireless remote capability operate incorrectly with this player's remote control. |
| Audio | 9. TV and other components operate incorrectly. |
• Plugs are not pushed in sufficiently, or plugs are disconnected. • Connection plugs and jacks are dirty. • The player is connected to a stereo amp's PHONO input jack. • Audio cable connection is incorrect. • Play is paused. • Stereo amp operation is incorrect. (In particular, check that input selection for CD, LD etc. is correct.) |
| Audio | 10. There's no sound. Sound is distorted. | • Digital output is set for 96 kHz. Digital output may not be possible with certain discs. |
| Audio | 11. DVD sound volume level is low. | • DVD sound volume level may sound lower than other discs, but this is due to the disc's recording system, and is not due to the player malfunctioning. |