Installation Guide for AVIC-F3210BT

System Setup

• Reconnect the negative (-) battery terminal.
• Start the engine.
• Press the RESET button while the detachable device is attached.
• Set the language.
• Drive on an unobstructed road until the GPS signal is received normally.
• Make necessary adjustments (e.g., set the time, change other settings).

Installation Precautions

• Do not install where it obstructs vision, impairs safety features (airbags, hazard lights), or hinders driver operation.
• Install between seats to prevent impact during sudden braking.
• Avoid airbag deployment zones.
• Guard against electromagnetic interference by keeping antennas and their leads away from the navigation unit and other cables.
• Ensure proper heat dissipation by leaving space behind the unit.
• Do not install near heaters or in hot areas to prevent semiconductor laser damage.
• Ensure easy removal of the detachable device or drawer.

Connection Precautions

• Use with a 12-volt battery and negative earthing only.
• Disconnect the negative (-) battery cable before installation.
• Use appropriate speakers (over 50W, 4 to 8Ω).
• Use the correct fuse rating.
• Pull connectors, not leads, when disconnecting.
• Ensure the vehicle has an ACC (accessory) position on the ignition switch.
• Secure all wiring with clamps or tape; do not leave bare wires exposed.
• Route cables away from moving parts (steering wheel, gearstick, etc.).
• Avoid routing wires in high-temperature areas.
• Do not cut or extend the GPS aerial cable.
• Do not shorten any leads as it may affect protection circuits.
• Never power other electronics by tapping into the navigation system's power supply lead.