Brand: Price Pfister
Category: Plumbing Fixtures
Document Type: Installation Guide
Language: EN
Available Languages: EN , ES
Installation Guide for 808 Series
Uploaded: April 20, 2026, 8:11 p.m.
Warranty Information
Lifetime Limited Mechanical & Pfinish Warranty for original purchaser, with commercial application limitations.
Before proceeding: Read all instructions. Call a professional if uncertain. Install according to local codes. Ensure compatibility with Price Pfister 0X8 series valve.
Shut off water supply: Locate and turn off water valves. Remove old unit and clean mounting surface if replacing.
Tools recommended: PTFE tape/sealant, Philips screwdriver, flashlight, pipe wrench, adjustable wrench, cloth, 3/32" Allen wrench. A pipe nipple is required for spout installation.
Shut off water supply: Locate and turn off water valves. Remove old unit and clean mounting surface if replacing.
Tools recommended: PTFE tape/sealant, Philips screwdriver, flashlight, pipe wrench, adjustable wrench, cloth, 3/32" Allen wrench. A pipe nipple is required for spout installation.
Troubleshooting and error codes
| PROBLEM | SOLUTION |
|---|---|
| Dripping from tub spout or shower head | Clean Cartridge Assembly. Check O-rings on cartridge. Reassemble. If leak persists, replace cartridge. |
| Hot and cold water inlets are not on | Ensure both hot and cold water inlets are turned on. |
| Water flow is very low | Check Cartridge Assembly for debris. Check shower head for sediment. |
| Water starts hot, becomes cooler as handle is rotated counter clockwise | Check hot and cold inlet positions. Refer to valve body instructions for back-to-back installation if needed. This is a hazardous situation. |
| Water flows from shower head while filling tub | Check Valve Body position (SHWR up, TUB down). |
| Water not hot enough | Remove handle, sleeve, flange. Refer to valve body instructions for temperature range adjustment. |
| Water flows from tub spout while using shower | The seal in the diverter mechanism may be dislodged. Spout may need replacement. |
| Temperature or flow is not consistent | Clean Cartridge Assembly. Shut off water, remove handle, sleeve, flange. Inspect cartridge and inlets for debris, flush with water. Reassemble and test. Replace cartridge if problem persists. |
| Sleeve is too short | An extension kit (910-563) is available. |