Brand: Qilive
Category: Audio
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for Q.1158
Uploaded: April 20, 2026, 7:45 p.m.
Warranty Information
Refer to the warranty card for detailed warranty information.
Basic Operation
Powering On/Off: Plug in the device. It turns on and displays the default time. To turn off the radio, press and hold the FM/AM/Off button for 2 seconds.
Setting Time: Press and hold the Time/Station button to enter time setting mode. Use the Hour/Tuning down and Minute/Tuning up buttons to set the hours and minutes. Press the Time/Station button or wait 5 seconds to save.
Using the Radio: Press the FM/AM/Off button to turn on the radio (defaults to FM). Press again to switch between FM and AM. Adjust volume using Alarm 1/Volume down and Alarm 2/Volume up buttons. Adjust the antenna for best reception.
Setting Alarms: Press and hold the Alarm 1/Volume down button to enter alarm setting mode. Use the Hour/Tuning down and Minute/Tuning up buttons to set the alarm time. Press the Alarm 1/Volume down button or wait 5 seconds to save. Change alarm mode (buzzer/radio) by pressing the Alarm 1/Volume down button.
Sleep Timer: When the radio is on, press the Snooze/Sleep/Dimmer button to set the automatic turn-off time (10-90 minutes).
Time Projection: Press the Time projection button to start/stop projection. Adjust focus by turning the lens holder. Rotate projection by 180 degrees using the AMS/180° flip button.
Troubleshooting and error codes
| Problem | Possible Cause | Solution |
|---|---|---|
| No power | Power cable not plugged in. | Ensure the power cable is securely plugged into the device and a working electrical outlet. |
| No sound | Volume is set to minimum. Radio not tuned. | Increase the volume. Tune to a radio station. |
| Poor radio reception | Antenna not adjusted properly. Device location. | Extend and reposition the FM antenna. Try moving the device to a different location or changing the frequency. |
| Alarm not sounding | Alarm is turned off. | Ensure the alarm is turned on. Check the alarm mode (buzzer/radio). |
| Time display not accurate | Power failure without backup battery. | Re-set the time after power restoration. Consider inserting a backup battery. |