Manual for SR-257 / 366

Manual for SR-257 / 366

Brand: SANYO

Category: Refrigerator

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: Nov. 21, 2025, 8:47 p.m.

Warranty Information

Your Sanyo refrigerator requires no maintenance and has no specific warranty period mentioned.

Cleaning and Maintenance: Turn off refrigerator and remove foods, shelves, trays. Wash interior liner with warm water and baking soda solution, then rinse and wipe. Avoid soaps, detergents, and spray cleaners. Wash ice cube trays, drip tray, and shelves with mild detergent. Wipe exterior with soft cloth dampened with soapy water. Use mild soapy water for door gasket. Never use acids, chemical thinners, gasoline, or benzene. Your Sanyo refrigerator requires no maintenance.
Temperature Control: Adjust the cold control knob; closer to 'MAX' makes the temperature lower. Temperature varies with food quantity and door openings. Set to 'MAX' for quick ice cube needs. The unit may cycle on/off more frequently due to its compactness.
Defrosting: Defrost when ice/frost reaches 1/4 inch thick. Remove foods and trays, place drip tray. Set cold control to 'OFF' to start defrosting. Defrosting takes a few hours; open door and use warm water on frosted areas to speed it up. Never use sharp or metallic tools, boiling water, or defrost heaters. After defrosting, remove drip tray, and set cold control to desired position to restart.

Troubleshooting and error codes

Problem Possible Cause Solution
Refrigerator does not run 1. Not plugged in. 1. Plug into grounded outlet.
2. Cold control set to OFF. 2. Set to MAX and allow 20 minutes.
3. Power failure. 3. Check house fuse or circuit breaker.
Motor runs constantly 1. Cold control set to MAX. 1. Set to MIN and check if motor stops.
2. Door open too long or too often. 2. Close door.
3. Improper temperature control setting. 3. Adjust control.
4. Large amount of warm food added. 4. Allow to cool before adding.
5. Frost is 1/4 inch thick. 5. Defrost.
Freezing compartment has excessive frost 1. Door open too long or too often. 1. Close door.
2. Improper temperature control setting. 2. Adjust control.
3. Humidity is too high. 3. Reduce humidity if possible.
Food is not cold enough 1. Cold control set too low. 1. Set control closer to MAX.
2. Door open too long or too often. 2. Close door.
3. Frost is 1/4 inch thick. 3. Defrost.
4. Improper installation (air flow blocked). 4. Ensure proper clearance.
Refrigerator vibrates or makes noise 1. Unit not level. 1. Adjust leveling feet.
2. Parts of the cabinet are touching the wall. 2. Move unit away from wall.
3. Refrigerant flowing noise. 3. This is normal.
Interior light does not work 1. Bulb burned out. 1. Replace bulb.
2. Door switch is not functioning. 2. Contact service.
Privacy Policy