Brand: SEARS
Category: Other
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for 214.50145
Uploaded: Sept. 12, 2025, 4:19 a.m.
Warranty Information
One year warranty on Craftsman floor jack against defects in material or workmanship.
- Raising the Jack: Close release valve, block wheels, position jack under vehicle's lifting point, pump handle until saddle nears contact, then pump to desired height. Support vehicle with stands before working.
- Lowering the Jack: Slowly open release valve counterclockwise. Keep hands and feet clear.
- Maintenance: Regularly check oil level and add proper hydraulic jack oil. To drain, remove plug and release valve, then refill and cycle handle to remove air. Prevent rust by checking ram/plunger and storing lowered. Annual inspection by authorized facility recommended.
Troubleshooting and error codes
| POSSIBLE JACK PROBLEMS | POSSIBLE CAUSES AND SOLUTIONS | |||||
| Jack will not lift load | Jack will lift load, but will not hold | Jack will not lower completely | Poor jack lifting. Pump feels spongy | Jack will not lift to full height | Handle raises by itself when jack is under load | (Refer to Operation and Maintenance procedures for detailed information) |
| X | Release valve not tightly closed. To close or tighten, turn release valve clockwise. | |||||
| X | X | X | X | X | Air is in hydraulic system. Release air from system. | |
| X | Oil level is low in jack. Add oil as required. | |||||
| X | X | X | 1. Oil reservoir is over-filled. Drain out some oil. 2. Lubrication of moving parts is necessary. | |||
| X | Power unit is malfunctioning. Replace the power unit. | |||||