Manual for DV-SV92S(L)

Manual for DV-SV92S(L)

Brand: SHARP

Category: Audio

Document Type: Manual

Language: EN

Uploaded: Nov. 21, 2025, 7:33 p.m.

Basic Play

  1. Press OPERATE.
  2. Press OPEN/CLOSE to open the disc tray.
  3. Place a disc onto the tray, title side facing up.
  4. Press OPEN/CLOSE to close the disc tray.
  5. (If a menu is displayed) Use navigation buttons to select the preferred title.
  6. Press SELECT.

Stopping Play

Press STOP twice for permanent stop. Pressing STOP once enables the Resume function.

Fast Forward/Reverse

Press SLOW/SEARCH during playback.

Skip Forward/Backward

Press SKIP/FRAME during playback.

Pause

Press PLAY/PAUSE during playback. Press PLAY/PAUSE or SELECT to resume.

Step Forward/Backward

Press PLAY/PAUSE to pause, then SKIP/FRAME to advance frame by frame.

Troubleshooting and error codes

Problem Solutions
The picture quality is poor (DVD)
• Make sure the DVD surface is not damaged. (Scratches, fingerprints, etc.)
• Clean the DVD and try again.
• Make sure that the DVD is in the disc tray with the label facing up.
• A wet DVD or condensation may affect performance of the player. Allow the player one or two hours in Standby mode for it to dry.
Disc does not play
• No disc in the player.
• Place a disc onto the tray.
• Disc incorrectly loaded.
• Wrong type of disc. The player cannot play CD-ROMs etc.
• Use disc in supported formats described on page 5.
• The region code of the DVD must match that of the player.
Wrong OSD language
• Select the language in the SETUP menu.
The language for the sound or subtitles on a DVD cannot be changed.
• Multilingual sound and/or subtitles not recorded on the DVD.
• Try to change the sound or subtitles using the menu of the DVD. Some DVDs do not allow changes to these settings without using the menu of the DVD.
Some functions (Angle, Zoom, etc.) do not work
• These functions are not available on the DVD.
• Angle can only be changed when the angle symbol is displayed.
Abnormal or no picture
• Check that the player is connected to the TV properly and that all connections between the player and other attached equipment are secure.
• Have you pressed the correct buttons on the remote control? Try once more.
• Make sure the "TV TYPE" and "VIDEO OUTPUT" are set correctly in "VIDEO SETUP" menu.
No sound
• Check that the volume is set to an audible level.
• Make sure you have not switched the sound off accidentally.
• Check the connections of the audio connectors, see pages 10 to 13.
Distorted sound
• Check that the appropriate listening mode setting is correct.
No response from remote control
• Check that the batteries are positioned correctly.
• Change the batteries.
• Operate the remote control within 30° angle on either side of the remote control sensor, up to a distance of approximately 6 meters.
If nothing works
If you have tried the above solutions and nothing seems to work, try switching the player off and on again. If you still encounter operational problems, unplug the AC power cord and wait for a few minutes to allow the player to reset itself completely. If none of these actions is successful, contact your supplier or DVD player repair technician. Never attempt to repair a defective DVD player yourself.
Privacy Policy