Brand: SHARP
Category: Home Appliances
Document Type: Manual
Language: EN
Manual for QW-DX41F47W-EN
Uploaded: Nov. 21, 2025, 7:06 p.m.
- Ensure electricity and water supply match specifications.
- Remove all internal packaging.
- Set the water softener level and fill the rinse aid compartment.
- Fill the salt compartment (if available) before the first use.
- Load dishes appropriately, ensuring not to obstruct spray arms.
- Select the most suitable programme for your dishes.
- Start the machine by closing the door or pressing the start button.
- Refer to the control panel for programme selection, delay start, half load options, and indicator lights for salt and rinse aid.
- For cleaning, refer to the sections on cleaning filters, spray arms, and the interior.
Troubleshooting and error codes
| FAULT | POSSIBLE CAUSE | TROUBLESHOOTING |
|---|---|---|
| The programme does not start. | Your Dishwasher is not plugged in. | Plug your Dishwasher in. |
| Your Dishwasher is not switched on. | Switch your Dishwasher on by pressing the On/Off button. | |
| Fuse blown. | Check your indoor fuses. | |
| Water inlet tap is closed. | Turn on the water inlet tap. | |
| Your Dishwasher door is open. | Close the Dishwasher door. | |
| Water inlet hose and machine filters are clogged. | Check the water inlet hose and machine filters and make sure they are not clogged. | |
| Water remains inside the machine. | Water drain hose is clogged or twisted. | Check the drain hose, then either clean or untwist it. |
| The filters are clogged. | Clean the filters. | |
| The programme is not finished yet. | Wait until the programme is finished. | |
| Machine stops during washing. | Power failure. | Check mains power. |
| Water inlet failure. | Check water tap. | |
| Shaking and hitting noises are heard during a wash operation. | The spray arm is hitting the dishes in the lower basket. | Move or remove items blocking the spray arm. |
| Partial food wastes remain on the dishes. | Dishes placed incorrectly, sprayed water not reaching affected dishes. | Do not overload baskets. |
| Dishes leaning against each other. | Place dishes as instructed in the section on loading your dishwasher. | |
| Not enough detergent used. | Use the correct amount of detergent, as instructed in the programme table. | |
| Wrong wash programme selected. | Use the information in the programme table to select the most appropriate programme. | |
| Whitish stains remains on dishes. | Rinse aid dosage and/or water softener setting set too low. | Increase rinse aid and/or water softener level. |
| High water hardness level. | Increase water softener level and add salt. | |
| Dishes do not dry. | Drying option is not selected. | Select a programme with a drying option. |
| Rust stains form on the dishes. | High level of salt in wash water. | Adjust the water hardness level using water hardness table. |
| Salt compartment cap not closed properly. | Check that the salt compartment cap is closed properly. | |
| Too much salt spilled in the Dishwasher while filling it with salt. | Use funnel while filling salt to the compartment to avoid spillage. | |
| Detergent remains in the detergent compartment. | Detergent was added when the detergent compartment was wet. | Make sure detergent compartment is dry before use. |