Brand: SIEMENS
Category: Washing Machine
Document Type: Manual
Language: EN
Brand: SIEMENS
Category: Washing Machine
Document Type: Manual
Language: EN
Uploaded: Nov. 21, 2025, 6:12 p.m.
This liability warranty is valid for the service life of the appliance.
| Fault | Possible cause | Remedial action |
| Spin cycle actuated several times. | Not a fault. Unbalanced load detection system is attempting to compensate the imbalance by spinning the washing several times. | Always wash large and small items together. |
| The washing has not been spun correctly. | Large laundry items have become entangled and are not evenly distributed in the drum. For safety reasons the high-speed spin cycle was automatically reduced. | Always wash large and small items together. |
| Programme duration extended. | Not a fault. Aqua sensor has extended the rinse cycle. | - |
| Programme duration extended. | Not a fault. Foam detection system has actuated an additional rinse cycle in order to dissipate the foam. | Adjust the detergent dosage for the next wash cycle. |
| Washing result not satisfactory. | Not a fault. Unbalanced load detection system is attempting to compensate the imbalance by spinning the washing several times. | Always wash large and small items together. |
| Washing result not satisfactory. | Soiling is greater than expected. | Select a suitable programme or "Stains" or "Prewash" additional option. |
| Detergent residue on the washing. | Detergent was underdosed. | Dose detergent according to the manufacturer's instructions. |
| Detergent residue on the washing. | Some phosphate-free detergents contain water-insoluble residue which may appear as light stains on the washing. | Select "Rinse" immediately or brush the washing after the drying cycle. |
| Grey residue on the washing. | Soiling caused by ointment, grease or oil. | Select maximum detergent dosage and maximum permitted temperature for the next wash cycle. |
| Unexpected programme termination. | "on/off" button inadvertently pressed. | Restart programme. |
| Text on display panel | Possible cause | Remedial action |
| "Tap closed?" | Tap not turned on. | Turn the tap on. Programme will continue automatically. |
| "Tap closed?" | Inlet hose kinked or pinched. | Eliminate cause. |
| "Tap closed?" | Filter blocked in water inlet hose. | Clean filter, see Page 44. |
| "Tap closed?" | Water pressure too low. | Eliminate cause. |
| "Tap closed?" even though a lot of water has run in. | Safety function has detected an appliance defect. | Do not open the appliance door as water may run out! Repeatedly select "Drain" programme until the water level is low enough to remove the laundry. Call Customer Service. |
| "Pump blocked?” | Pumped blocked by foreign objects. | Clean pump, see Page 43. |
| "Pump blocked?” | Drainage pipe and/or drainage hose blocked. | Clean drainage pipe and/or drainage hose. |
| "Door open?” | Door not closed properly. | Check whether an item of laundry is jammed; close the door. |
| Aqua-Stop actuated? | Water in the base pan; appliance leaking. | Call Customer Service. |