Brand: SIEMENS
Category: Washing Machine
Document Type: Manual
Language: EN
Manual for WM 2085
Uploaded: Nov. 21, 2025, 9:25 p.m.
Warranty Information
The warranty period is 24 months from the date of purchase.
Basic Operation Summary
To operate the washing machine:
- Load laundry into the drum and close the door.
- Add detergent to the appropriate drawer.
- Select the desired wash programme and temperature using the respective selectors.
- Press the "ON/OFF" button to start the cycle.
- The machine will automatically end the programme with a spin cycle.
- After the programme ends, switch the machine OFF using the "ON/OFF" button and wait for 2 minutes before opening the door to remove the laundry.
Refer to the manual for specific programme details and additional functions.
Troubleshooting and error codes
| Problems | Possible causes / remedies |
|---|---|
| The power indicator light does not come on | - The plug is not correctly, or only loosely, inserted into the socket. - A fuse has blown in the domestic wiring. |
| Power failure | - Power failure. |
| Washing sequence does not start | - "ON/OFF" button not pressed. - Door not properly closed. |
| No water to be seen during washing | This is not a malfunction! The water inside the machine is below the level at which it becomes visible. |
| Poor washing results | - Degree of soiling was greater than usual. - Change type and amount of detergent. - Select maximum permissible temperature for fabric type. - Select a more powerful wash programme. |
| Foam comes out of the detergent drawer | Too much detergent was used. Switch off the machine for approximately 5-10 minutes. To reduce the amount of foam, put a tablespoon of fabric softener mixed with 1/2 litre water into the detergent drawer. For the next wash, adjust the amount of detergent accordingly. |
| Foam still visible after last rinse | Certain detergents tend to produce more suds but this does not affect the rinsing result. |
| Motor noise | This is not a malfunction! It is normal for noises to be heard while the motor is running in. |
| Pump noise | This is not a malfunction! It is normal for noises to be heard from the pump during the start-up phase or the final stage of draining the drum. |
| Vibrations when washing and spinning | - Transit bolts were not removed. Follow the directions in the installation instructions (page 33). - The machine's feet were not secured in place when the machine was installed. Realign the machine using a spirit level, securing the machine's feet according to the installation instructions. |
| Machine does not spin or does not pump out the water | Pump blocked |