Installation Guide for CDX-GT350

Installation/Connections

Parts list 1

The numbers in the list are keyed to those in the instructions.

• The bracket ① and the protection collar ④ are attached to the unit before shipping. Before mounting the unit, use the release keys ③ to remove the bracket ① and the protection collar ④ from the unit.
• Keep the release keys ③ for future use as they are also necessary if you remove the unit from your car.

Removing the protection collar and the bracket 4

Before installing the unit, remove the protection collar ④ and the bracket ① from the unit.

1. Remove the protection collar ④
   1. Engage the release keys ③ together with the protection collar ④
   2. Pull out the release keys ③ to remove the protection collar ④
2. Remove the bracket ①
   1. Insert both release keys ③ together between the unit and the bracket ① until they click.
   2. Pull down the bracket ①, then pull up the unit to separate.

Mounting example 5

Installation in the dashboard

• Bend these claws outward for a tight fit, if necessary (5-2).
• Make sure that the 4 catches on the protection collar ④ are properly engaged in the slots of the unit (5-3).

Mounting the unit in a Japanese car 6

You may not be able to install this unit in some makes of Japanese cars. In such a case, consult your Sony dealer.

Note
To prevent malfunction, install only with the supplied screws ⑤.

How to detach and attach the front panel 7

Before installing the unit, detach the front panel.

7-A To detach

Before detaching the front panel, be sure to press OFF. Press OPEN, then slide the front panel to the right, and gently pull out the left end of the front panel.

7-B To attach

Place the hole Ⓐ of the front panel onto the spindle Ⓑ on the unit, then lightly push the left side in.

Warning if your car's ignition has no ACC position

After turning the ignition off, be sure to press and hold OFF on the unit until the display disappears. Otherwise, the display does not turn off and this causes battery drain.

RESET button

When the installation and connections are completed, be sure to press the RESET button with a ball-point pen, etc., after detaching the front panel.