Manual for SPP-206

Manual for SPP-206

Brand: SONY

Category: Cordless Phone

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: Nov. 21, 2025, 8:51 p.m.

Manual Publish Date: 1998-01-01

Warranty Information

The manual does not explicitly state a warranty period.

Getting Started

Step 1: Unpack the phone and accessories.

Step 2: Set up the base phone, including finding the best location.

Step 3: Insert the battery pack into the handset and charge for over 12 hours.

Making Calls

Press TALK or pick up the handset from the base. Dial the number. Press OFF or replace the handset to end the call.

Receiving Calls

Press TALK or pick up the handset. Press OFF or replace the handset to end the call.

Troubleshooting and error codes

Problem Solution
Five short beeps when pressing TALK.
  • Check base phone installation.
  • Move handset closer to base phone.
  • Charge battery for some time.
No dial tone.
  • Check telephone line cord connection.
  • Ensure battery is fully charged.
Phone does not communicate at all.
  • Check dialing mode setting.
  • Ensure dial tone is heard before dialing.
Dialing is not repeated correctly.
  • Verify the last dialed number.
  • Ensure the last dialed number is not too long.
  • The last dialed number was erased.
Five short error beeps when trying to redial.
  • Check if the last dialed number is correct.
  • Ensure the last dialed number is not over 32 digits.
  • The last dialed number was erased.
Handset does not ring.
  • Battery may be weak; charge for over 12 hours.
  • Check base phone installation.
  • Move handset closer to base phone.
  • Recharge digital security code.
  • Ensure call generator is activated.
Interference during conversation.
  • Move handset closer to base phone.
  • Press CHANNEL to switch to a clearer channel.
  • Move base phone away from noise sources.
A beep every three seconds and TALK/BATT LOW lamp flashes.
  • Battery is weak; charge for over 12 hours. You can use the handset for less than a minute without charging.
Cannot store a speed dial number.
  • Check speed dial storage procedure.
  • Do not store when the handset is in use.
Five short error beeps when attempting speed dial call.
  • You entered a speed dial number without a stored phone number.
Incorrect speed dial.
  • Store the correct number.
Handset does not ring when called from base phone.
  • Handset may be in use.
  • Battery is weak; charge for over 12 hours.
  • Move handset closer to base phone.
  • Move base phone away from noise sources.
CHARGE lamp does not light up when handset is placed on base.
  • Clean charging terminals on base and handset.
  • Ensure handset is properly placed on base.
Battery life is short.
  • Battery charged for less than 12 hours.
  • Battery life has expired.
Privacy Policy