Manual for SPP-N1003

Manual for SPP-N1003

Brand: SONY

Category: Cordless Phone

Document Type: Manual

Language: EN

Available Languages: EN , ES

Uploaded: Nov. 21, 2025, 7:35 p.m.

Warranty Information

Refer to your WARRANTY card for warranty information and contact an authorized Sony service station for repairs.

Making and Receiving Calls

To make a call, pick up the handset, press TALK, wait for the TALK/BATT LOW lamp to light up and for the dial tone, then dial the number. To end the call, press OFF.

To receive a call, pick up the handset when it rings or press TALK. When finished, replace the handset or press OFF.

Additional Tasks

  • Adjust handset volume with the VOL switch.
  • Temporarily switch to tone dialing by pressing * TONE after connecting.
  • Change ringer type by pressing CHANNEL/RINGER when the handset is not in use.
  • Switch to another call (call waiting) by pressing FLASH.

Speed Dialing

Store phone numbers by pressing PGM, then SPEED DIAL, selecting a key, entering the number, and pressing PGM again. To make a call using speed dial, press TALK, then SPEED DIAL, and enter the speed dial number.

Paging

To page the handset, press HANDSET LOCATOR on the base unit. The handset will ring for about one minute. To end the page, press OFF on the handset.

Troubleshooting and error codes

Symptom Remedy
The handset does not make or receive a call. Reset the digital security code. Place the base unit away from noise sources such as TV, FM radio or PC. Make sure the base unit is connected to an AC outlet. The battery pack may be discharged. Charge the battery pack for more than 12 hours.
You hear no dial tone. Make sure the telephone line cord is securely connected to the telephone outlet.
The handset does not connect at all, even the numbers you dial are correct. Choose an appropriate dialing mode again.
The handset does not redial correctly. Make sure the number (including the tone and pause digits, if used) you last dialed is less than 32 digits.
The handset does not make a speed dialing call. Make sure there is a phone number correctly stored in the speed dialing. Store the desired phone number once more.
The handset does not ring. Make sure the base unit is connected to an AC outlet. The battery may have little or no power. Charge the battery pack for more than 12 hours. Place the base unit away from noise sources.
The handset does not ring when paging from the base unit. Charge the battery pack for more than 12 hours.
You hear a beep every three seconds and the TALK/BATT LOW lamp flashes. The battery pack may be discharged. Charge the battery pack for more than one minute. After this initial one minute, you may be able to use the handset, but more than 12 hours are necessary for full charging.
The handset does not work. Es posible que la batería esté descargada. Cárguela durante más de un minuto. Después de este minuto inicial, usted podrá utilizar el microteléfono, pero para la carga completa de la batería serán necesarias 12 horas.
You cannot here anything from the headset. Unplug the headset cord, and plug it again into the (HEADSET) jack on the handset. Wipe the tip of the headset cord plug.
Privacy Policy