Brand: SONY
Category: Digital Camera
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for DSC-RX100M3/RX100M3G
Uploaded: Nov. 21, 2025, 8:46 p.m.
Manual Publish Date: 2018-09-01
Warranty Information
This manual does not contain warranty information.
Service Manual for SONY DSC-RX100M3/RX100M3G
Key Sections:
The manual provides critical safety information, component identification, and detailed procedures for servicing the camera.
It also includes diagnostic codes and methods for resolving common issues.
Key Sections:
- Service Notes: Precautions for replacing specific boards (SY-1036, Lens, Imager, EVF), Wi-Fi function check, self-diagnosis function, flash error processing, EVF cleaning.
- Disassembly/Assembly: Detailed step-by-step instructions for removing and installing various components, including ornamental rings, barrier blocks, frame blocks, and internal boards.
- Repair Parts List: Comprehensive list of parts with reference numbers and descriptions, including exploded views.
- Printed Wiring Boards: Schematics and layout diagrams for key circuit boards.
The manual provides critical safety information, component identification, and detailed procedures for servicing the camera.
It also includes diagnostic codes and methods for resolving common issues.
Troubleshooting and error codes
| Repaired by | Block | Detailed Code | Symptom/State | Correction | ||
|---|---|---|---|---|---|---|
| C | 1 | 3 | 0 | 1 | Memory card is unformatted. | Format the memory card. |
| C | 1 | 3 | 0 | 1 | Memory card is broken. | Insert a new memory card. |
| C | 1 | 3 | 0 | 1 | Memory card type error | Insert a supported memory card. |
| C | 3 | 2 | 0 | 1 | Trouble with hardware | Turn the power off and on again. |
| E | 4 | 1 | 0 | 0 | Abnormality of wireless LAN module or host CPU. | Replace the SY-1036 board. |
| E | 4 | 1 | 0 | 1 | Abnormality of network control device. | Turn the power off and on again. |
| E | 6 | 1 | 0 | 0 | Difficult to adjust focus (Cannot initialize focus) | Retry turn the power on by the power switch. If it does not recover, check the focus MR sensor signal of lens block (pin ④, ⑤ of CN6800 on the SY-1036 board). If it is OK, check the focus motor drive IC (IC6802 on the SY-1036 board). |
| E | 6 | 1 | 1 | 0 | Zoom operations fault (Cannot initialize zoom lens.) | Retry turn the power on by the power switch. Check the zoom reset sensor signal of lens block (pin ⑨ of CN6800 on the SY-1036 board) when zooming is performed when the zoom button is operated. If it is OK, check the zoom motor drive IC (IC6802 on the SY-1036 board). |
| E | 6 | 1 | 3 | 0 | Reset position detection error on the stepper iris initializing | Turn power off and turn power on again. |
| E | 6 | 2 | 0 | 2 | Abnormality of IC for steadyshot. | Check or replacement of the IC for steadyshot (IC6802 on the SY-1036 board). |