Brand: STAYER
Category: Power Tools
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for TD 185 BRUSHLESS TD355B
Uploaded: April 20, 2026, 7:50 p.m.
Warranty Information
STAYER offers a 36-month guarantee against manufacturing defects, limited to 12 months for industrial/professional use.
Work Area Safety: Keep work area clean and well lit. Do not operate in explosive atmospheres. Keep children and bystanders away.
Electrical Safety: Ensure plug matches outlet. Avoid contact with earthed surfaces. Do not expose to rain or liquids. Do not use the cord for carrying. Use outdoor-approved extension cords. Use RCD in damp locations.
Personal Safety: Stay alert and use common sense. Do not use if tired or under the influence. Wear protective equipment. Prevent unintentional starting. Remove adjusting keys before turning on. Avoid overreaching. Dress properly. Use dust extraction if provided.
Power Tool Use and Care: Do not force. Use the correct tool. Do not use if the switch is defective. Disconnect from power before adjustments. Store out of reach of children. Maintain tools. Keep cutting tools sharp.
Specific Safety Instructions: Always fix workpiece with clamp. Do not adjust clamp while running. Keep hands and body away from disc. Check blade protector. Do not use abrasive discs. Use sharpened discs of the correct size. Use only manufacturer-supplied accessories. Check maximum blade speed. Do not use damaged discs. Be careful not to bend the disc.
Recoil: Secure workpiece, hold saw firmly, control disc stoppage, use supports for large workpieces. Do not use damaged discs. Ensure clamp is secure. Use appropriate Widia discs.
Operation: Follow instructions for use, cutting angle adjustment, vise operation, cutting depth control, start/stop, and debris removal.
Troubleshooting and error codes
| Problem | Solution |
| Power tool plug does not match the outlet. | Do not modify the plug. Use appropriate adapters if necessary (for non-grounded tools). |
| Tool does not turn on. | Check power connection. Ensure switch is in the 'ON' position. If issue persists, contact service. |
| Disc is bent or misaligned during cutting. | Ensure workpiece is securely clamped. Use appropriate, undamaged discs. Do not force the cut. |
| Disc gets stuck. | Release trigger immediately and wait for the disc to stop completely. Investigate the cause. |
| Tool overheating. | Do not use continuously for over 31 minutes. Allow to cool. Ensure proper ventilation. |