Brand: TOSHIBA
Category: DVD Player
Document Type: Manual
Language: EN
Manual for HD-EP30KB
Uploaded: Nov. 21, 2025, 9:17 p.m.
Setup:
1. Connect the player to a TV and audio system using appropriate cables.
2. Connect to a network via LAN if desired.
3. Connect the power cord and turn on the player.
4. Follow on-screen setup for Language, Time, Resolution, and Audio output.
Playing Discs:
1. Load a disc into the tray.
2. Press the PLAY button.
3. Use controls for pause, stop, fast forward/reverse, selecting audio, subtitles, and camera angles.
Customizing Settings:
1. Press SETUP to access the setup menu.
2. Navigate to Picture, Audio, Language, or General settings.
3. Select and adjust settings as needed.
Troubleshooting and error codes
| Symptom | Remedy | Page |
| No power. | Is the power plug disconnected? Check the power connection. | 17 |
| No picture. | Is the cable for connecting the player and TV disconnected or not connected properly? Check the connections. | 15 |
| Switch the input of the connected TV to the signal from the player. | – | |
| Are both the HDMI OUTPUT jack and the COMPONENT VIDEO OUTPUT jacks connected simultaneously? Select either connection and make the appropriate setting. | 15 | |
| No sound. | Is the audio cable disconnected? | 14, 16 |
| Is the volume of the device turned down to the minimum level? Check the volume. | – | |
| Switch the audio input of the device connected by the audio cable to the input from the player. | – | |
| The disc does not play. | Make sure the disc type can be played with the player. | 8 |
| Is the disc dirty or scratched? Check or clean the disc. | 8 | |
| If the disc is a DVD-RW or DVD-R disc, finalize the disc before attempting to play it with the player. | – | |
| Playback picture has noise. | If video from the player is watched via a video recorder or on a TV with a built-in video recorder, the copy guard may prevent images from being displayed properly. Be sure to connect the player directly to the TV. | 15 |
| Playback picture does not move smoothly. | "Resolution Setting" > "up to 1080p/24Hz" is selected. Change the setting. | 20 |
| The remote control does not work. | Are the batteries of the remote control dead? Replace the batteries. | 13 |
| HDMI Control (REGZA-Link) does not work. | Make sure the remote control is within range and pointed in the correct direction. | 13 |
| HDMI Control (REGZA-Link) does not work. | Make sure the HDMI cable is firmly connected, then turn on both the TV and the player again. | 35 |
| Screen freezes and no buttons work. | Pressing ON/STANDBY button on the player for approximately ten seconds forces the player to turn off. Turn the player off and then on again. | – |
| After powering on, "Clock Set" menu appears. | The power supply to the player may have been disconnected. Reset the clock. | 19 |