Brand: YORK
Category: Air Conditioner
Document Type: Manual
Language: EN
Available Languages: ES , EN
Brand: YORK
Category: Air Conditioner
Document Type: Manual
Language: EN
Available Languages: ES , EN
Uploaded: April 20, 2026, 7:52 p.m.
The remote control allows operation of various air conditioning functions including ON/OFF, mode selection (COOL, DRY, FAN, HEAT, AUTO), temperature adjustment (TEMP+/TEMP-), fan speed (FAN SPEED), air deflector position (SWING), sleep mode (SLEEP), and timer functions (CLOCK, T-ON, T-OFF).
Dispose of packaging according to regulations. Uses HFC-410A and POE oil. Contains greenhouse gas covered by the Kyoto Protocol.
| Problem | Possible cause and correction |
|---|---|
| A. Air conditioning unit inoperative. | 1.-Make sure fuse is not blown or main switch has not been activated. 2.-Is main switch on OFF? 3.-Has a mistake been made when programming? |
| B. Unit does not cool sufficiently. | 1.-Is the filter dirty? See instructions on how to clean filter. 2.-The room was probably too warm when turning the unit on. Wait until the unit has had time to lower the room temperature. 3.-Has the adequate temperature been programmed? 4.-Are the unit air intake or outlet grids obstructed? |
| C. There is a bad odour in the room. | 1.-Make sure said odour is not from dampness of walls, carpets, furniture or other fabrics in the room. |
| D. Air conditioning unit makes noise. | 1.-A noise similar to running water: Caused by refrigerant going through refrigerant circuit. 2.-A noise similar to a shower: Caused by dehumidification water treated inside the unit. |
| E. Seems as if condensed water is flowing from the unit. | 1.-Condensation is produced when the unit cools the air in the room. |
| F. Air conditioning unit inoperative 3 minutes after reset. | 1.-Due to a system protecting device. Wait 3 minutes for operation to start again. |
| G. The remote control screen becomes weak or goes off. | 1.-The batteries may need changing. 2.-Do not invert polarity of the batteries when changing. |
| H. Air conditioning unit does not respond to remote control unit, or to direct manual control. | 1.-The batteries may need changing. 2.-Do not invert polarity of the batteries when changing. 3.-Contact your Service Centre to have them check the power supply of your installation. |