Brand: ZANUSSI
Category: Dishwasher
Document Type: Manual
Language: EN
Manual for ZDV12002FA
Uploaded: Nov. 21, 2025, 7:58 p.m.
EASY START
1. On/off button: Powers the appliance on and off.
2. Programme indicators: Lights up to show the selected programme.
3. Indicators: Signal salt level and end of programme.
4. Programme button: Used to select a programme and enter user mode.
PROGRAMMES
Several programmes are available for different types of soil and loads:
- ECO 2): For normal soil, crockery and cutlery. Efficient use of water and energy.
- Normal soil: For heavy soil, crockery, cutlery, pots and pans.
- Normal soil: For normal soil, crockery and cutlery.
- Fresh soil: For fresh soil, crockery and cutlery. Quick wash.
- Prewash: For rinsing dishes quickly to prevent food from bonding. Do not use detergent.
SETTINGS
Programme Selection Mode: Appliance is ready to have a programme selected.
Cancel Function: Press the programme button until all indicators are on to cancel a running programme.
USER MODE
Access user mode to adjust water softener level and acoustic signal.
Adjusting Water Softener: Adjust based on water hardness for optimal results.
BEFORE FIRST USE
1. Adjust water softener level.
2. Fill salt container.
3. Fill rinse aid dispenser.
4. Open water tap.
5. Run a programme without detergent or dishes to remove processing residuals.
DAILY USE
1. Open water tap.
2. Turn on appliance.
3. Load baskets.
4. Add detergent.
5. Select and start programme.
ADDING SALT/RINSE AID/DETERGENT
Follow visual instructions for adding salt, rinse aid, and detergent. Use compartment B for prewash detergent if applicable.
STARTING A PROGRAMME
1. Keep door ajar.
2. Turn on appliance.
3. Select programme.
4. Close door to start.
OPENING THE DOOR
Appliance stops when door is opened and resumes when closed.
END OF PROGRAMME
Turn off appliance or it will automatically switch off after a period to save energy.
Troubleshooting and error codes
| You cannot activate the appliance. | Make sure that the mains plug is connected to the mains socket. Make sure that there is no a damage fuse in the fuse box. |
| The programme does not start. | Make sure that the appliance door is closed. The appliance has started the procedure to re-charge the resin inside the water softener. The duration of the procedure is approximately 5 minutes. |
| The appliance does not fill with water. The end indicator flashes 1 time intermittently. Acoustic signal sounds 1 time intermittently. |
Make sure that the water tap is open. Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. Make sure that the water tap is not clogged. Make sure that the filter in the inlet hose is not clogged. Make sure that the inlet hose has no kinks or bends. |
| The appliance does not drain the water. The end indicator flashes 2 times intermittently. Acoustic signal sounds 2 times intermittently. |
Make sure that the sink spigot is not clogged. Make sure that the drain hose has no kinks or bends. |
| The anti-flood device is on. The end indicator flashes 3 times intermittently. Acoustic signal sounds 3 times intermittently. |
Close the water tap and contact an Authorised Service Centre. |