Brand: ZANUSSI
Category: Tumble Dryer
Document Type: Manual
Language: EN
Brand: ZANUSSI
Category: Tumble Dryer
Document Type: Manual
Language: EN
Uploaded: Nov. 21, 2025, 7:59 p.m.
No specific warranty period is mentioned in the manual.
| Problem | Possible solution |
|---|---|
| You cannot activate the appliance. | Make sure that the mains plug is connected to the mains socket. Check fuse in fuse box (domestic installation). |
| The programme does not start. | Press Start/Pause. |
| The appliance door does not close. | Make sure that the appliance door is closed. Make sure that the installation of the filter is correct. |
| The appliance stops during operation. | Make sure that the laundry does not catch between the appliance door and the rubber seal. Make sure that the water container is empty. Press Start/Pause to start the programme again. |
| The cycle time is too long or unsatisfactory drying result.1) | Load is too small, increase the load or use the Time Dry programme. Make sure that the weight of the laundry is applicable to the duration of the programme. Make sure that the filter is clean. The laundry is too wet. Spin the laundry in the washing machine again. Ensure that the room temperature is higher than +5°C and lower than +35°C. Optimal room temperature is 18°C to 25°C. Set the Time Dry or the Extra Dry programme.2) |
| The tumble dryer does not heat up. The laundry inside is cold and wet. The filter is clogged. The emergency heater shut-down. | Clean the filter (see chapter CARE AND CLEANING). |
| Display shows 1 min or few minutes to the cycle end for longer time. The laundry inside is cold and wet. The filter is clogged. The emergency heater shut-down. | Clean the filter (see chapter CARE AND CLEANING). |
| The display shows Err. | If you want to set a new programme, deactivate and activate the appliance. Make sure that the options are applicable to the programme. |
| The display shows an Error code (e.g. E51). | Deactivate and activate the appliance. Start a new programme. If the problem occurs again, contact the Service. |