Brand: ZANUSSI
Category: Washing Machine
Document Type: Manual
Language: EN
Available Languages: EN , ES
Manual for T 845 V
Uploaded: Nov. 21, 2025, 8:03 p.m.
Warranty Information
The manual does not specify a warranty period.
To operate your washing machine:
- Load laundry: Open the lid and drum, insert laundry, and close the drum and lid securely.
- Add detergent: Pour powder detergent into the appropriate compartment. Add softener if desired.
- Select spin speed: Choose based on fabric type and desired dryness.
- Select temperature: Match program and care label recommendations.
- Choose pushbuttons: Select 'On/Off', 'Half load', or 'Rinse plus' as needed.
- Select program: Turn the program selector clockwise for the desired wash cycle.
- Start program: Press the 'On/Off' pushbutton to begin.
- End of program: The machine stops automatically. Switch off using 'On/Off', unplug, and close the water tap. Leave the lid and drum open to air.
Important: Always unplug before cleaning or maintenance. Ensure proper installation and water/power connections.
Troubleshooting and error codes
| The washing machine will not start or will not fill: |
the washing machine is not correctly connected, the electrical installation is not working, the lid of your washing machine and the drum flaps are not correctly closed, you did not control the program start correctly, there is a power failure, the water supply is closed off, the water tap is closed, the water inlet is blocked. |
|---|---|
| The washing machine fills up but empties again immediately: | the drain siphon is attached too low (see installation section). |
| The washing machine will not spin or will not drain: |
the drain pipe is blocked or kinked, the drain filter is blocked, the < the height of the drain siphon is wrong. |
| There is water on the floor around the washing machine: |
excess detergent has made too much foam that overflowed, the detergent is not suitable for machine washing, the drain siphon is not hooked on properly, the drain filter was not put back into place, the water inlet pipe is leaking. |
| Washing results are not satisfactory: |
the detergent is not suitable for machine washing, there is too much washing in the drum, the washing program is not appropriate, there is not enough detergent. |
| The machine is vibrating or noisy: |
not all the packing was removed from the machine (see unpacking section), the washing machine is not leveled and properly packed, the washing machine is too close to the wall or furniture, the washing is not well distributed in the drum, the load is not sufficient. |
| The washing cycle is much too long: |
the water inlet is blocked, there was a power supply failure or the water was cut off, the motor temperature safety device tripped, the water inlet temperature is lower than normal, |
| The washing machine stops during a washing cycle: |
the water or electricity supply is defective, a rinse hold was programmed. |
| The cover does not open during the cycle: | the cover cannot open until 1 to 2 minutes after the washing machine has stopped. |
| Softener or Javel water flows* through the overflow orifice when filling: |
you did not put in the right amount, the siphons at the back of the detergent dispenser are blocked. |