Name: Manual for AVR-S760H - Troubleshooting and error codes + PDF Download
Brand: DENON

Manual for AVR-S760H - Troubleshooting and error codes + PDF Download

Brand: DENON

Category: Stereo Receiver

Manual Type:

Language:

Uploaded: April 8, 2025, 4:24 a.m.

Manual Publish Date: 2021-01-01

Warranty Summary

Warranty information is not explicitly stated in this owner's manual.

To operate the DENON AVR-S760H receiver, follow these basic steps:

Turning the power on: Press the POWER button to turn the unit on or off.
Selecting the input source: Press the input source select buttons (e.g., Blu-ray, Bluetooth, USB) or turn the SOURCE SELECT knob to choose the desired input.
Adjusting the volume: Use the VOLUME buttons to increase or decrease the volume.
Muting the sound: Press the MUTE button to temporarily turn off the sound.
Selecting a sound mode: Press MOVIE, MUSIC, or GAME to choose a suitable sound mode for your content or use the PURE button for Direct or Auto sound modes.

Troubleshooting and error codes

Examples	Error details	Measures
No speakers found.	Sound calibration microphone is not detected. Not all speakers could be detected.	Connect the included Sound calibration microphone to the SETUP MIC jack of this unit. Check the speaker connections.
Ambient noise is too high or level is too low	There is too much noise in the room. Speaker or subwoofer sound is too low.	Either turn off any device generating noise or move it away. Perform again when the surroundings are quieter. Check the speaker installation and the direction in which the speakers are facing. Adjust the subwoofer’s volume.
Front R : None	The displayed speaker could not be detected.	Check the connections of the displayed speaker.
Front R : Phase	The displayed speaker is connected with the polarity reversed.	Check the polarity of the displayed speaker. For some speakers, this error message may be displayed even if the speaker is properly connected. If you are sure the connection is correct, press ▸ to select “Ignore”, then press ENTER.

Examples	Error details	Measures
No speakers found.	Sound calibration microphone is not detected. Not all speakers could be detected.	Connect the included Sound calibration microphone to the SETUP MIC jack of this unit. Check the speaker connections.
Ambient noise is too high or level is too low	There is too much noise in the room. Speaker or subwoofer sound is too low.	Either turn off any device generating noise or move it away. Perform again when the surroundings are quieter. Check the speaker installation and the direction in which the speakers are facing. Adjust the subwoofer’s volume.
Front R : None	The displayed speaker could not be detected.	Check the connections of the displayed speaker.
Front R : Phase	The displayed speaker is connected with the polarity reversed.	Check the polarity of the displayed speaker. For some speakers, this error message may be displayed even if the speaker is properly connected. If you are sure the connection is correct, press ▸ to select “Ignore”, then press ENTER.