Brand: GRACO
Category: Car Seat
Manual Type:
Language:
Manual for SnugRide Classic Connect 30 - Troubleshooting and error codes + PDF Download
Uploaded: March 29, 2025, 7:46 p.m.
Manual Publish Date: 2013-10-01
Warranty Summary
Warranty information is not explicitly mentioned in this manual.
Basic Operation Summary:
- Adjusting Handle: Press buttons on both sides and rotate to desired position.
- Positioning Harness Straps: Adjust straps to be even with or just below child's shoulders.
- Securing Child: Open chest clip, place child, buckle harness, snap chest clip, and tighten straps.
- Installation: Can be installed with vehicle seat belt or LATCH system, always rear-facing.
- Reclining: Ensure proper recline using level indicators on base or restraint.
- Final Safety Check: Push down on restraint and twist/pull to ensure secure installation before each drive.
Troubleshooting and error codes
| Problem | Solution |
|---|---|
| Buckle Latching Issues | Clean the buckle by placing it in warm water and gently agitating it. Press the red button several times while in the water. Ensure no soap or lubricants are used. Dry thoroughly before use. If the buckle still does not latch, contact Graco at 1-800-345-4109. |
Troubleshooting and error codes
| Problem | Solution |
|---|---|
| Buckle Latching Issues | Clean the buckle by placing it in warm water and gently agitating it. Press the red button several times while in the water. Ensure no soap or lubricants are used. Dry thoroughly before use. If the buckle still does not latch, contact Graco at 1-800-345-4109. |