Brand: HUSKY
Category: Tile Saw
Manual Type:
Language:
Manual for THD750L - Troubleshooting and error codes + PDF Download
Uploaded: April 8, 2025, 1:39 p.m.
Warranty Summary
This product is covered by a one year warranty from the date of purchase against defects in workmanship or material.
Basic Operation Steps:
- Fill the water reservoir before cutting.
- Connect the unit to a power source.
- Turn the switch to "ON" to start the machine.
- Adjust the parallel fence or angle guide for desired cut.
- Push the tile towards the blade with even pressure.
- Turn the switch to "OFF" to stop the machine.
- Clean the saw after use.
Troubleshooting and error codes
| Problem | Possible Cause | Solution |
|---|---|---|
| Motor stops turning | Plugs not fully connected, Voltage issue, Switch problem, GFCI reset needed | Verify plugs, Check voltage, Check switch, Reset GFCI, Repair machine |
| Blade won't cut properly | Blade worn, Blade bent/cracked, Insufficient water | Check blade rim, Check blade condition, Check water level |
| Laser line projection hard to see | Bright work area, Weak batteries, Dust/water on laser cover | Reduce light, Replace batteries, Clean laser cover |
| Laser line not projected | Laser switch off, Batteries exhausted | Check laser switch, Replace batteries |
Troubleshooting and error codes
| Problem | Possible Cause | Solution |
|---|---|---|
| Motor stops turning | Plugs not fully connected, Voltage issue, Switch problem, GFCI reset needed | Verify plugs, Check voltage, Check switch, Reset GFCI, Repair machine |
| Blade won't cut properly | Blade worn, Blade bent/cracked, Insufficient water | Check blade rim, Check blade condition, Check water level |
| Laser line projection hard to see | Bright work area, Weak batteries, Dust/water on laser cover | Reduce light, Replace batteries, Clean laser cover |
| Laser line not projected | Laser switch off, Batteries exhausted | Check laser switch, Replace batteries |