Manual for 253 - Troubleshooting and error codes + PDF Download

Manual for 253 - Troubleshooting and error codes + PDF Download

Brand: KENMORE

Category: Refrigerator

Manual Type:

Language:

Uploaded: April 8, 2025, 1:52 p.m.

Manual Publish Date: 2008-01-01

Warranty Summary

One-year full warranty on refrigerator, five-year full warranty on sealed refrigeration system.
Temperature Controls:
- Initial setting: Middle position.
- Adjust gradually, wait 24 hours between changes.
- Colder: Turn towards 'Cold'. Warmer: Turn towards 'Warm'.
- Freezer control affects only freezer temp, refrigerator control affects both.

Ice Service (if applicable):
- Turn on: Lower wire signal arm.
- First ice in ~24 hours, discard first batches.
- Turn off: Lift wire signal arm.
- Clean ice container regularly.

Troubleshooting and error codes

Problem Possible Cause and Solution
Refrigerator does not run.
  • Ensure plug is tightly pushed into electrical outlet.
  • Check/replace fuse or reset circuit breaker.
  • Temperature control is turned to "O".
  • Refrigerator may be in defrost cycle. Wait 20 minutes.
Freezer temperature too cold. Refrigerator temperature is satisfactory.
  • Set freezer control to a warmer setting. Allow 24 hours to stabilize.
Refrigerator temperature too cold. Freezer temperature is satisfactory.
  • Set refrigerator control to a warmer setting. Allow 24 hours to stabilize. Adjust freezer if needed.
Refrigerator is noisy or vibrates.
  • The cabinet is not level.
  • Floor is weak.
Odors in refrigerator.
  • Interior needs to be cleaned.
  • Foods that produce odors should be covered or wrapped.
Cabinet light not working.
  • Replace light bulb.
  • Ensure plug is tightly pushed into electrical outlet.
  • Light switch may be stuck. Push in light switch.
Automatic ice maker not working. (some models)
  • Ensure the Wire Signal Arm is not in UP position.
  • Ice maker should produce 4 to 5 pounds of ice in a 24 hour period.
  • Water supply is turned off.
  • Water pressure is too low.
  • The freezer is not cold enough.

Troubleshooting and error codes

Problem Possible Cause and Solution
Refrigerator does not run.
  • Ensure plug is tightly pushed into electrical outlet.
  • Check/replace fuse or reset circuit breaker.
  • Temperature control is turned to "O".
  • Refrigerator may be in defrost cycle. Wait 20 minutes.
Freezer temperature too cold. Refrigerator temperature is satisfactory.
  • Set freezer control to a warmer setting. Allow 24 hours to stabilize.
Refrigerator temperature too cold. Freezer temperature is satisfactory.
  • Set refrigerator control to a warmer setting. Allow 24 hours to stabilize. Adjust freezer if needed.
Refrigerator is noisy or vibrates.
  • The cabinet is not level.
  • Floor is weak.
Odors in refrigerator.
  • Interior needs to be cleaned.
  • Foods that produce odors should be covered or wrapped.
Cabinet light not working.
  • Replace light bulb.
  • Ensure plug is tightly pushed into electrical outlet.
  • Light switch may be stuck. Push in light switch.
Automatic ice maker not working. (some models)
  • Ensure the Wire Signal Arm is not in UP position.
  • Ice maker should produce 4 to 5 pounds of ice in a 24 hour period.
  • Water supply is turned off.
  • Water pressure is too low.
  • The freezer is not cold enough.