Brand: LIVING&CO
Category: Dehumidifier
Manual Type:
Language:
Manual for DYD-S10A412 - Troubleshooting and error codes + PDF Download
Uploaded: April 8, 2025, 1:10 p.m.
Manual Publish Date: 2018-10-01
Warranty Summary
This LIVING&CO product is covered by a 3-year warranty when accompanied by proof of purchase.
Switching On/Off: Press the power button to turn the dehumidifier on or off. It starts in manual continuous dehumidifying mode with low fan speed.
Auto Shut-off Timer: Use the timer button to set a shut-off time between 00-24 hours.
Humidity Setting: Adjust desired humidity levels using up/down buttons, ranging from CO (continuous) to 30%-80%.
Fan Speed Option: Change fan speed (high/low) with the fan speed button, except in Laundry drying and Defrost modes.
Laundry Drying Function: Activate Laundry Drying for 6 hours of continuous dehumidification with high fan speed.
Safety Childlock: Press and hold the fan speed button for 2 seconds to lock/unlock all buttons.
Troubleshooting and error codes
| PROBLEM | POSSIBLE CAUSE | SOLUTION |
|---|---|---|
| The device does not work | The power is not connected | Insert the plug into the wall outlet |
| The device does not work | The water tank is full | Empty the tank |
| The device does not work | The tank has not been replaced correctly | Replace the tank |
| Water removal capacity is too low | Runtime is too short | Be patient and leave the unit running for a longer duration |
| Water removal capacity is too low | Ambient temperature or humidity is too low | It is normal that the device does not dehumidify in these conditions |
| The device works, but reduces the relative humidity inadequately | The room is too big | We recommend using a dehumidifier with a greater capacity |
| The device works, but reduces the relative humidity inadequately | There is too much ventilation | Reduce ventilation (e.g. close windows and shut doors) |
| The device works, but reduces the relative humidity inadequately | The air filter is clogged | Clean the air filter |
| The device works, but reduces the relative humidity inadequately | Set humidity is higher than the ambient humidity | Set the humidity lower than ambient humidity |
| Dehumidifier is blowing out warm air | The dried air is passed over heating coils before it is blown into the room as part of the dehumidifying process | This is normal, a dehumidifier is not an air cooler |
| The display is not showing the humidity set point | The display shows the room relative humidity not the set point | Press the humidity control button once to see the target relative humidity |
| Water on floor | There is residual water in tank, and the device is lurched too much by moving | Be careful when moving the tank |
| The dehumidifier is noisy | The air filter is blocked or the device is on an uneven surface | Clean the filter or put the device on a flat surface |
Troubleshooting and error codes
| PROBLEM | POSSIBLE CAUSE | SOLUTION |
|---|---|---|
| The device does not work | The power is not connected | Insert the plug into the wall outlet |
| The device does not work | The water tank is full | Empty the tank |
| The device does not work | The tank has not been replaced correctly | Replace the tank |
| Water removal capacity is too low | Runtime is too short | Be patient and leave the unit running for a longer duration |
| Water removal capacity is too low | Ambient temperature or humidity is too low | It is normal that the device does not dehumidify in these conditions |
| The device works, but reduces the relative humidity inadequately | The room is too big | We recommend using a dehumidifier with a greater capacity |
| The device works, but reduces the relative humidity inadequately | There is too much ventilation | Reduce ventilation (e.g. close windows and shut doors) |
| The device works, but reduces the relative humidity inadequately | The air filter is clogged | Clean the air filter |
| The device works, but reduces the relative humidity inadequately | Set humidity is higher than the ambient humidity | Set the humidity lower than ambient humidity |
| Dehumidifier is blowing out warm air | The dried air is passed over heating coils before it is blown into the room as part of the dehumidifying process | This is normal, a dehumidifier is not an air cooler |
| The display is not showing the humidity set point | The display shows the room relative humidity not the set point | Press the humidity control button once to see the target relative humidity |
| Water on floor | There is residual water in tank, and the device is lurched too much by moving | Be careful when moving the tank |
| The dehumidifier is noisy | The air filter is blocked or the device is on an uneven surface | Clean the filter or put the device on a flat surface |