Manual for 046-0265-2 - Troubleshooting and error codes + PDF Download

Manual for 046-0265-2 - Troubleshooting and error codes + PDF Download

Brand: Mastercraft

Category: Garage Door Opener

Manual Type:

Language:

Uploaded: April 8, 2025, 1:43 p.m.

Warranty Summary

Mastercraft 046-0265-2 garage door opener motor has an 8 year warranty, parts have a 2 year warranty, and accessories have a 1 year limited warranty against defects.

Operating the Door:

  • Activate by pressing the wall console or remote.
  • Door behavior depends on its current state (open, closed, moving, obstructed).
  • Opener light turns on when activated and off automatically after 3 minutes.
  • Manual light control available on the wall console.

Remote Control:

  • Hold the button until the door moves.

Keypad Operation:

  • Enter pin code plus [#] for single door operation.
  • Enter pin code plus [#] plus [door number] for multiple doors.

Manual Operation:

  • Pull red trolley release handle to disengage during power failure or obstruction.
  • Flip trolley lever up to re-engage.

Troubleshooting and error codes

LED Light Flashing LED Display Flashing Symptom Solution
3 Flashes
L
L
The wall console is in lock mode. The remote controls are deactivated. Unlock the wall console.
5 Flashes
0
0
Overtime. The motor is running continuously over 30 seconds in one direction. Ensure the opener is correctly installed and attached to the garage door. Adjust the travel limit.
10 Flashes
6
6
Safety beam sensor blocked. Check safety beam sensor alignment and obstructions.
15 Flashes
F
F
The door is not fully open or fully closed. Check for obstructions, re-adjust travel limits and force.
Continuous Flashing
C
C
Wall console wire shorted. Check wall console wires for a short.

Troubleshooting and error codes

LED Light Flashing LED Display Flashing Symptom Solution
3 Flashes
L
L
The wall console is in lock mode. The remote controls are deactivated. Unlock the wall console.
5 Flashes
0
0
Overtime. The motor is running continuously over 30 seconds in one direction. Ensure the opener is correctly installed and attached to the garage door. Adjust the travel limit.
10 Flashes
6
6
Safety beam sensor blocked. Check safety beam sensor alignment and obstructions.
15 Flashes
F
F
The door is not fully open or fully closed. Check for obstructions, re-adjust travel limits and force.
Continuous Flashing
C
C
Wall console wire shorted. Check wall console wires for a short.