Brand: Miele
Category: Dishwasher
Manual Type:
Language:
Manual for G 646 SC - Troubleshooting and error codes + PDF Download
Uploaded: April 8, 2025, 12:49 a.m.
Warranty Summary
Warranty information is detailed within the Warning and Safety instructions section of this manual.
Basic Operation Summary:
- Switching On:
- Ensure spray arms are unobstructed.
- Close the dishwasher door.
- Open the stopcock (if closed).
- Press the "On/Off" button.
- Starting a Programme:
- Select the desired programme using the programme selector.
- Press the "Start" button.
- Switching Off:
- Turn the programme selector to the "Stop" position.
- Press the "On/Off" button.
Troubleshooting and error codes
| Problem | Possible cause | Remedy |
|---|---|---|
| The "Start" indicator light does not flash after the appliance has been switched on with the "On/Off" button. | The door is not properly closed. | Close the door firmly. |
| The appliance is not plugged in. | Insert the plug. | |
| The fuse is defective or has tripped. | Replace the fuse (see data plate for minimum fuse rating). | |
| The dishwasher does not start after the "Start" button has been pressed; the "Start" indicator light is flashing. | The programme selector is at the "Stop" position. |
Turn the programme selector to the required programme. Press the "Start" button. |
| The dishwasher stops during a programme. | The fuse is defective or has tripped. | Replace the fuse (see data plate for minimum fuse rating). |
| The indicator light "Inlet/Drain" lights up and flashes alternately | The stopcock is closed. | Open the stopcock fully. |
| The water inlet filter is blocked. | Before rectifying the problem you must: - Turn the programme selector to the "Stop" position. - Switch the dishwasher off using the "On/Off" button. then: - Clean the water inlet filter, see "Solving problems". |
|
| The Waterproof system has reacted. | Call the Miele Service Department. |
Troubleshooting and error codes
| Problem | Possible cause | Remedy |
|---|---|---|
| The "Start" indicator light does not flash after the appliance has been switched on with the "On/Off" button. | The door is not properly closed. | Close the door firmly. |
| The appliance is not plugged in. | Insert the plug. | |
| The fuse is defective or has tripped. | Replace the fuse (see data plate for minimum fuse rating). | |
| The dishwasher does not start after the "Start" button has been pressed; the "Start" indicator light is flashing. | The programme selector is at the "Stop" position. |
Turn the programme selector to the required programme. Press the "Start" button. |
| The dishwasher stops during a programme. | The fuse is defective or has tripped. | Replace the fuse (see data plate for minimum fuse rating). |
| The indicator light "Inlet/Drain" lights up and flashes alternately | The stopcock is closed. | Open the stopcock fully. |
| The water inlet filter is blocked. | Before rectifying the problem you must: - Turn the programme selector to the "Stop" position. - Switch the dishwasher off using the "On/Off" button. then: - Clean the water inlet filter, see "Solving problems". |
|
| The Waterproof system has reacted. | Call the Miele Service Department. |