Brand: Nuna
Category: Car Seat
Manual Type:
Language:
Manual for PIPA LITE RX - Troubleshooting and error codes + PDF Download
Uploaded: April 8, 2025, 3:36 a.m.
Warranty Summary
The product is covered by a custom warranty per product, starting from the day of purchase.
Securing Child in Child Restraint:
- Loosen harness, press button to release chest clip and buckle.
- Place child in seat in seated position.
- Adjust harness height so straps are at or just below child's shoulders.
- Guide arms through straps.
- Insert buckle tongues until clicks.
- Listen for clicks, pull to verify latched.
- Snap chest clip, slide towards buckle.
- Tighten harness by pulling adjustment strap until snug.
- Position chest clip at armpit level.
Installation with PIPA RELX Base (Rigid Latch):
- Rotate rigid latch anchors down.
- Position base in forward-facing vehicle seat with stability leg deployed.
- Install latch guides if preferred.
- Push rigid latch anchors to connect to vehicle lower anchors.
- Check installation: pull base, green indicators should be visible.
Troubleshooting and error codes
| Problem | Possible Cause |
|---|---|
| No troubleshooting table found in the manual. | Please refer to the manual for detailed instructions or contact customer service. |
Troubleshooting and error codes
| Problem | Possible Cause |
|---|---|
| No troubleshooting table found in the manual. | Please refer to the manual for detailed instructions or contact customer service. |